Table of Contents
Advertisement
Installation
Remove limits
If you need to remove the east/west limits.
When you activate this command, the motor will turn itself to the
0° (Zero) position.
However, the next time you select a channel, the motor will return
to its proper position.
Channel search
The Channel search procedure can be carried out in different ways.
The menu will look different depending on what option you
selected in the "Antenna/satellite selection" menu.
If you selected "One antenna/one LNB configuration", select
"Automatic", "Manual" or "Advanced Manual" search.
If you selected "Multisatellite/DiSEqC switch configuration" or
"Motor antenna configuration", you also need to indicate which
satellite you wish to search from, using the cursor left/right
button.
Automatic search
If you selected "One antenna/one LNB configuration" or
"Multisatellite/DiSEqC switch configuration":
• Press OK to start searching for channels.
If you selected "Motor antenna configuration":
• Select a predefined channel and then adjust the motor (if
necessary) using the cursor left/right button.
• Press OK to start searching for channels.
Manual search
The information that must be entered in this menu is available in
satellite TV magazines or on the Internet.
Transponder frequency: Specify the frequency in MHz using the
number buttons. If you enter the wrong value, erase it using cursor
left.
polarization: Select Horizontal, Vertical, Circular left or Circular
right.
Symbol rate: Enter using the number buttons. If you enter the
wrong value, erase it using cursor left.
Network search: Select "Yes" if you want to search all
transponders that are connected to a specific network.
Adjust motor: This alternative is only visible if you have set the
motor antenna configuration. If necessary, adjust the motor for the
current satellite.
• Press OK to start searching for channels.
GB 14
Advertisement
Table of Contents
