Specification; Symbols In The Manual; Symbols On The Machine - Husqvarna 325S25 Operator's Manual

2. Specification

Model name and number
Purpose
Dry weight ∗
External dimensions of main unit
(length x width x height) ∗∗
Capacity of chemical fluid tank (litres)
Capacity of fuel tank
Pump Type
Speed
Spray output
Maximum water absorption (litres/min)
Motor transmission system
Engine Type
Model number
Exhaust capacity (cc)
Fuel used
Lubricating oil used
Admixture ratio
Carburetor
Ignition system
Spark plugs
Starter system
Stopping system
Air cleaner
Standard accessories
* When nozzle (supplied) is attached.
** Nozzle and back belt are not included.
Due to product improvements, these specifications are subject to change without notice.

3. Symbols in the manual

(1) (2)
(1) Read owner's manual before operating this ma-
chine.
(2) Wear head, eye and ear protection.
(3) Wear foot protection.
(4) Wear gloves.
(5) Warning / Attention
Never modify your machine.
We won't warrant the machine, if you use the
remodeled power sprayer or if you don't ob-
serve the proper usage written in the manual.
(kg)
(mm)
(litres)
(rpm)
Normal (MPa)
Maximum (MPa)
(3) (4) (5)
Husqvarna Back-Packed Motorized Sprayer
Spraying agricultural chemicals and cold water
for pest control, weeding, and growth control
335x470x640
Centrifugal clutch
Single-cylinder air-cooled 2-cycle gasoline engine
Lubricating oil/gasoline mix
2-cycle engine oil
Gasoline 50 : Oil 1 (when using Husqvarna genuine oil)
Diaphragm, rotary valve type
Electronic controlled flywheel magnet type
CHAMPION RCJ-6Y
Recoil starter type
Primary cable short circuit
1 spray rod, 1 rod, 1 cock, 1 grip, 1 joint,
1 hose, 1 plug wrench

4. Symbols on the machine

For safe operation and maintenance, symbols are carved
in relief on the machine. According to these indications,
please be careful not to make a mistake.
The port to refuel the MIX GASOLINE
Position: FUEL TANK CAP
The direction to close the choke
Position: AIR CLEANER COVER
The direction to open the choke
Position: AIR CLEANER COVER
325S25
9.8
25
0.6
Plunger type
1450
0.5 - 3.5
3.5
4.8
G26LS
25.4
Dry type
325S25
GB-3