2. Specifications 2-1 Table of Specifications MODEL CE935G ITEM TIMER 60 MINUTES POWER SOURCE 230V/50HZ, AC POWER CONSUMPTION MICROWAVE : 1,500W,GRILL : 1,300W OUTPUT POWER FROM135W TO 900W (6 LEVEL POWER INCLUDING DEFROST) (IEC-705 TEST PROCEDURE) OPERATING FREQUENCY 2,450MHz MAGNETRON...
VOLTAGE TRANSFORMER secondary and filament terminals. It is extremely dangerous to work on or Bolts near these circuits with the oven energized. H. V. Trans DO NOT measure the voltage in the high voltage circuit including filament voltage of magnetron. Samsung Electronics...
1. Insertion depth of the thin metal plate should be 0.5mm or less. 4-3-4 Removal of Key Door & Spring Door "E" Remove pin hinge from Door "E" Detach spring from Door "E" and key door. Key Door Spring Samsung Electronics...
Switch coupler. 8. Connect all the leads to the drive motor. Drive Motor Cover Base Plate 9. Screw the drive motor cover to the base plate with a screw driver. Samsung Electronics...
Page 6
4-6-1 Removal of Control Box Assembly 1. Disconnect the connectors from the control box assembly. 2. Remove screws securing the control box Screw assembly. 3.Remove the knobs of the control box Ass'y. 4. Remove the screw securing the timer. Control Box Samsung Electronics...
2. Isolate the magnetron from the circuit by disconnecting its leads. 3. A continuity check across the magnetron filament terminals should indicate one ohm or less. 4. A continuity check between each filament terminal and magnetron case should read open. Cooling Fins Samsung Electronics...
Door Open Door Closed procedures. ∞ Primary switch 5. Confirm that the gap between the switch ∞ Monitor switch (COM-NC) housing and the switch actuator is no more than ∞ Secondary switch 0.5mm when door is closed. Samsung Electronics...
5. After heating for 2 minutes, measure the water temperature in each beaker. 6. Microwave heat distribution rate can be calculated as follows: Minimum Beaker Temperature Rise Heat Distribution = X 100(%) Maximum Temperature Rise The result should exceed 65%. Cooking Tray Samsung Electronics...
4) When measuring the leakage, always use the 2 inch spacer cone with the probe. Hold the probe perpendicular to the cabinet door. Place the CE935G GRILL spacer cone of the probe on the door and/or cabinet door seam and move along the seam, the door viewing window and the exhaust openings moving the probe in a clockwise direction at a rate of 1 inch/sec.
2) Defective con- The oven lamp does not light and fan motor Replace the timer. tacts of timer does not operate. NOTE: Interlock monitor switch must be replaced when the fuse is blown out. Samsung Electronics...
Page 12
3) Too small a If a small amount of food is heated repeatedly over To increase the oven load or no a long period of time, microwave turns off during load, place a glass of load operation. water into the oven. Samsung Electronics...
1) If there is no continuity in forward, direction the H.V.Diode is open. Replace. 2) If there is continuity in reverse direction, it's shorted. Fan motor Fan motor Check if the motor coil is open. Replace. does not rotate. Samsung Electronics...
BRN BRN RED : RED YEL : YELLOW BLK : BLACK PRIMARY SWITCH SECONDARY SWITCH MONITOR SWITCH Y/G : YELLOW GREEN MAGNETRON HIGH VOLTAGE DIODE TO CHASSIS HIGH VOLTAGE CAPACITOR H.V.FUSE SYMBOL COLOR BROWN BLACK BLUE HIGH VOLTAGE TRANSFORMER Samsung Electronics...
Need help?
Do you have a question about the CE935G and is the answer not in the manual?
Questions and answers