Niles SS-6 Installation & Operation Manual
  1. Manuals
  2. Brands
  3. Niles Manuals
  4. Recording Equipment
  5. SS-6
  6. Installation & operation manual

Niles SS-6 Installation & Operation Manual

Speaker selection system
Hide thumbs Also See for SS-6:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

®
Niles Audio
Corporation
©2004 Niles Audio Corporation. All rights reserved. Niles, the Niles logo and Blending High Fidelity and
Architecture are registered trademarks of Niles Audio Corporation. Because we strive to improve our
www.nilesaudio.com
products, Niles reserves the right to change product specifications without notice. The technical and
other information contained herein is not intended to set forth all technical and other specifications of
Niles products. Additional information can be obtained on-line at www.nilesaudio.com or by calling
12331 S.W. 130 Street
Niles at 1-800-289-4434. Printed in China 1/04 DS00359ACN
Miami, Florida 33186
Tel: (305) 238-4373
Fax: (305) 238-0185
I N S T A L L A T I O N & O P E R A T I O N G U I D E
SS-4/SS-6
SS-4/SS-6
SPEAKER SELECTION SYSTEM
B
H
F
L E N D I N G
I G H
I D E L I T Y
A
®
A N D
R C H I T E C T U R E

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SS-6 and is the answer not in the manual?

Questions and answers

Related Manuals for Niles SS-6

Summary of Contents for Niles SS-6

  • Page 1 ® Niles Audio Corporation ©2004 Niles Audio Corporation. All rights reserved. Niles, the Niles logo and Blending High Fidelity and Architecture are registered trademarks of Niles Audio Corporation. Because we strive to improve our www.nilesaudio.com products, Niles reserves the right to change product specifications without notice. The technical and other information contained herein is not intended to set forth all technical and other specifications of Niles products.

  • Page 2: Specifications

    Speaker Selection System Introduction TABLE OF CONTENTS The SS-4/SS-6 allows you to connect multiple pairs of speakers Introduction to your stereo receiver or amplifier and play any pair, any combination of pairs, or all pairs simultaneously. You don’t Features and have to worry about overloading your amplifier.
  • Page 3 1. Make sure the amplifier or receiver power is OFF and set the volume to minimum. 2. On the right side of the SS-4/SS-6’s front panel is a button labeled PROTECTION. This button activates the SS-4/SS-6’s impedance correction circuitry. The circuitry assures that your receiver or amplifier will see a safe operating load when play- ing multiple speaker pairs simultaneously.
  • Page 4 Using the SS-4 with Tube-Type Amplifiers Virtually all tube amplifiers must have a load connected at all times. If the amplifier to be connected to the SS-4/SS-6 is a tube amplifier, be sure to always have at least one pair of speakers switched on at all times.
  • Page 5 P E A K E R E L E C T I O N Tube Amplifier Niles SS-4 Niles Audio Corporation Miami, Florida USA AMPLIFIER SPEAKER 4 SPEAKER 3 SPEAKER 2 Y S T E M Recessed areas for custom room labels.

  • Page 6: Operation

    E L E C T I O N Operation There are two ways to use the SS-4/SS-6. You may play one pair of speakers at a time, or play multiple pairs simultaneously. If you intend to play more than one pair of speakers at the same time, you will need to become familiar with the opera- tion of the SS-4/SS-6’s Protection button.
  • Page 7 With four pairs of 4-ohm speakers playing, the load drops to slightly under 4 ohms. If you intend to use the SS-4/SS-6 with more than 2 pairs of 4-ohm speakers, it is recommended that you verify that the receiver or amplifier is capable of driving a 4-ohm load.

  • Page 8: Features And Benefits

    P E A K E R E L E C T I O N 3. Locate the on/off buttons on the SS-4/SS-6 which correspond to the speaker pairs you wish to play. Set them to the ON position. 4. Turn on the amplifier or receiver and select a source, such as the tuner or CD player.

This manual is also suitable for:

Ss-4

Table of Contents