NetApp CN1610 Cli Command Reference page 79

no snmp trap link-
status
snmp trap link-
status all
no snmp trap link-
status all
show
snmpcommunity
Chapter 3: Management Commands
This command disables link status traps by interface.
Note
This command is valid only when the Link Up/Down Flag is enabled.
Format
no snmp trap link-status
Mode Interface Config
This command enables link status traps for all interfaces.
Note
This command is valid only when the Link Up/Down Flag is enabled. See
"snmp-server enable traps
Format
snmp trap link-status all
Mode Global Config
This command disables link status traps for all interfaces.
Note
This command is valid only when the Link Up/Down Flag is enabled. See
"snmp-server enable traps
Format
no snmp trap link-status all
Mode Global Config
This command displays SNMP community information. Six communities are
supported. You can add, change, or delete communities. The switch does not have
to be reset for changes to take effect.
The SNMP agent of the switch complies with SNMP Versions 1, 2 or 3. For more
information about the SNMP specification, see the SNMP RFCs. The SNMP
agent sends traps through TCP/IP to an external SNMP manager based on the
SNMP configuration (the trap receiver and other SNMP community parameters).
linkmode" on page 71.
linkmode" on page 71.
75