Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Teracue Amino A140
Summary of Contents for Teracue Amino A140
- Page 1 Amino 140 User Guide Amino A140™ Amino A140 - The next generation MPEG-2 and MPEG-4 HD IPTV set top box (STB) User Guide V1.0 Teracue eyevis GmbH Schlossstr. 18 85235 Odelzhausen Germany Tel: +49 (0)8134-555-10 Fax: +49 (0)8134-555-199 info@teracue.com www.teracue.com...
- Page 2 Thank you! Mail to: support@teracue.com All information within this document is confidential to Teracue costumers and should not be copied or distributed to non Teracue customers. All Teracue products and all of its components are registered trademarks RADEMARKS licensed to Teracue.
-
Page 3: Table Of Contents
Amino 140 User Guide Content OVERVIEW ............................4 SETUP ............................. 5 ........................5 ORMAL SETTINGS ......................... 7 DVANCED SETTINGS 2.2.1 Video settings in the main menu: ..................7 2.2.2 Video settings in the user preferences: ................7 2.2.3 Browser settings: ......................... 8 2.2.3.1 Home Page ........................ -
Page 4: Overview
Amino 140 User Guide Overview This User Guide is written for the amino A140 with Opera 10 Firmware 2.1.3 and higher. Older firmware versions, also on amino 130, maybe look different, but have nearly the same features. The needed passwords are:... -
Page 5: Setup
Normal settings For a fast configuration please do the following steps. 1. Connect the amino 140 with power, LAN and a video cable to you TV, Teracue recommend HDMI to have the best quality. 2. Use an USB keyboard or the special amino IR keyboard, to enter the menu. - Page 6 Amino 140 User Guide 6. Change the IP-settings Teracue delivers all Aminos with DHCP enabled. If a DHCP Server is configured, you can start working immediately with the amino A140. For remote control, Teracue recommends disabling DHCP and configure the IP-address, Netmask and Gateway in the DHCP menu.
-
Page 7: Advanced Settings
Amino 140 User Guide Advanced settings 2.2.1 Video settings in the main menu: To turn the ‘IGMP end timeout’ or other timeouts off, please change these values to “0”. Figure 4: Video settings in the main menu 2.2.2 Video settings in the user preferences: To open the user preferences, please do following: a) A140: Press ‘MENU’... -
Page 8: Browser Settings
EM remote control Central Zapper http://<ServerIP>/ working_chan.html website Fake Key bigger Installations >10 Zapping EM remote control iCue website Fake Key http://<iCueServerIP>/teracue/aminoopera/login.aspx need iCue Server bigger Installations >10 Zapping ElementManager EM remote control http://<iCueServerIP>/EMZapper/working_chan.aspx Zapper Fake Key need Element Manager... -
Page 9: Gfx Resolution
Amino 140 User Guide 2.2.3.2 GFX resolution Independent to the used video resolution of the TV, this setting configures the graphic resolution in which the website is displayed. Teracue Websites are optimized for 720 HD. Figure 6: Amino Browser setting... -
Page 10: Amino Usage
User Guide Amino Usage There are different possibilities to use the amino A140. Use it like your TV at home, or switch the TV channels remotely or via a schedule. Open a multicast or unicast stream at the start page Press ‘F10’... -
Page 11: Central Channel Website
3.3.1 Element Manager The Teracue Element Manager offers the possibility to remotely control the amino from a PC or a media controller such as Crestron or AMX. Additional you are able to use the Element Manager scheduler for automated channel switching The details of the protocol are described in the Element Manger User Guide. -
Page 12: Upgrade
Download the Firmware ‘mc2.mcfs’ from:https://www.aminocom.com/support/amino-support-portal from Teracue, please write to support@teracue.com To use Teracue Element Manager, Teracue requires the Teracue Firmware to have all the functions available. 4.1.1 Upgrade from Webserver. How-to: prepare your Webserver that you could download the firmware. Test it with the browser on your Computer Browser e.g. -
Page 13: Upgrade The Chnls.txt
In smaller environment where you work with local channel List, edit the local channel list with Alt+C on every amino or do following: 4.2.1 New Firmware Build a new firmware with included ‘local channel list’, or ask Teracue for a new firmware. 4.2.2 Copy new chnls.txt .!. An improper chnls.txt can destroy the image. -
Page 14: Copy New Chnls.txt Via Tftp
Amino 140 User Guide 4.2.2.2 Copy new chnls.txt via TFTP Start a TFTP Server on your computer Teracue recommend TFTPD from http://tftpd32.jounin.net Figure 10: TFTP Server Copy the new chnls.txt to the TFTP folder Use putty from http://www.putty.org... -
Page 15: Faq
Please use Teracue Firmware 14.21 or higher b) Does Amino 140 support HLS streaming? Yes since Teracue Firmware 14.10 or higher HLS is supported c) Does Amino 140 support Teletext on HDMI Yes when in the Transport Stream Teletext is enabled you could open the Teletext with the recording button , or the text button. -
Page 16: Appendix
Amino 140 User Guide Appendix Invalid Video Mode A simple method of video mode recovery is the following: Power cycle the box, and while it is booting hold down the OK button on the remote and point to the front of the Amino (keep the button pressed). ... -
Page 17: Fake Key Protocol
The fake Key protocol does not give you any feedback. .!. Fake Keys is an unsecure protocol and should only be used in closed environments. .!. Fake Keys is not enabled on all Teracue Amino Firmware. .!. sending ‘0’ or wrong commands disable the IR receiver until next reboot. -
Page 18: Ir Remote Control Commands
Amino 140 User Guide 6.3.2 IR Remote control commands 6.3.2.1 The IR Remote Key IR Key Function Fake Key (Dez) Standby (toggle) Play, Pause, Stop, Record 7,12,9,11 Forward, Rewind 8,10 Red, Green, Yellow, Blue 20,21,22,23 Cursor up, down, left, right 37,38,39,40 UP, Down 33.34... -
Page 19: Complete Fake Key Codes
Amino 140 User Guide 6.3.2.2 Complete Fake Key codes Command Dezimal key_updown key_up key_down IR ON IR OFF CIR_BTN_CH_UP CIR_BTN_CH_DOWN CIR_BTN_VOL_UP CIR_BTN_VOL_DOWN CIR_BTN_MUTE CIR_BTN_TVPOWER CIR_BTN_VID_PLAY CIR_BTN_VID_FORWARD CIR_BTN_VID_STOP CIR_BTN_VID_REVERSE CIR_BTN_VID_RECORD CIR_BTN_VID_PAUSE CIR_BTN_VID_PLAYPAUSE CIR_BTN_RELOAD CIR_BTN_WWW_TV CIR_BTN_FORWARD CIR_BTN_HELP CIR_BTN_RECORD CIR_BTN_BACK CIR_BTN_RED CIR_BTN_GREEN CIR_BTN_YELLOW CIR_BTN_BLUE CIR_BTN_MENU CIR_BTN_HOME... - Page 20 Amino 140 User Guide Command Dezimal key_updown key_up key_down CIR_BTN_INFO CIR_BTN_STB CIR_BTN_EXIT CIR_BTN_GUIDE CIR_BTN_LAST CIR_BTN_DTV CIR_BTN_0 CIR_BTN_1 CIR_BTN_2 CIR_BTN_3 CIR_BTN_4 CIR_BTN_5 CIR_BTN_6 CIR_BTN_7 CIR_BTN_8 CIR_BTN_9 CIR_BTN_MOVIES CIR_BTN_MUSIC CIR_BTN_MEDIA CIR_BTN_RECORDIT CIR_BTN_PROMOS CIR_BTN_PHONE CIR_BTN_INPUT CIR_BTN_LASTCH CIR_BTN_CLOSEDCAPTION CIR_BTN_HOSP1 CIR_BTN_HOSP2 CIR_BTN_RED_META CIR_BTN_GREEN_META CIR_BTN_YELLOW_META CIR_BTN_BLUE_META CIR_BTN_RIGHT_MOUSE CIR_BTN_SKIP_BACK CIR_BTN_SKIP_FORWARD...
- Page 21 Amino 140 User Guide Command Dezimal key_updown key_up key_down CIR_BTN_ADD1 CIR_BTN_ADD2 CIR_BTN_ADD3 CIR_BTN_SEARCH CIR_BTN_SAP CIR_BTN_FAVOURITES CIR_BTN_VOD CIR_BTN_ADVANCE CIR_BTN_DAY_NEXT CIR_BTN_DAY_PREV CIR_BTN_ASPECT CIR_BTN_CC ENGLISH Keyboard Dezimal key_updown key_up key_down K_NULL K_ESC K_MINUS K_EQUALS K_BSPACE K_TAB K_LSQBR K_RSQBR K_ENT K_LCTRL...
- Page 22 Amino 140 User Guide Command Dezimal key_updown key_up key_down K_COLON K_APOST K_BACKTICK K_LSHIFT K_BSLASH K_COMMA K_FSTOP K_FSLASH K_RSHIFT K_KPASTER K_LALT K_SPACE K_CAPLCK K_F1 K_F2 K_F3 K_F4 K_F5 K_F6 K_F7 K_F8 K_F9 K_F10 K_NUMLCK K_SCRLCK K_KPHOME K_KPUP K_KPPUP K_KPMINUS...
- Page 23 Amino 140 User Guide Command Dezimal key_updown key_up key_down K_KPLEFT K_KP5 K_KPRIGHT K_KPPLUS K_KPEND K_KPDOWN K_KPPDOWN K_KPINS K_KPDEL K_F11 K_F12 K_KPENT K_RCTRL K_KPFSLASH K_PRSCR K_RALT K_HOME K_UP K_PUP K_LEFT K_RIGHT K_END K_DOWN K_PDOWN K_INS K_DEL K_PAUSE Amino IR Keyboard specific Dezimal key_updown key_up key_down...
-
Page 24: Examples
Amino 140 User Guide 6.3.2.3 Examples Open the Amino Menu send following commands To send the sequence Alt-M LEAVES OK you do the following: = 56 + 768 // press left Alt + (key_down) = 50 + 256 // M + (key_updown) = 56 + 512 // release left Alt + (key_up) = 38 + 256... - Page 25 Amino 140 User Guide List of figures 1: S ......................5 IGURE TART PAGE OF THE AMINO 2: L ........................5 IGURE OGIN AT THE AMINO 3: IP-C ....................6 IGURE ONFIGURATION AT THE AMINO 4: V ................... 7 IGURE IDEO SETTINGS IN THE MAIN MENU 5: S ' ..................
Need help?
Do you have a question about the Amino A140 and is the answer not in the manual?
Questions and answers