Troubleshooting - Landmann triton 4 Assembly And Operating Manual

Troubleshooting

If there is a fault despite due care, this chapter may help you to resolve the fault.
Fault
There is a smell of gas
Burner does not ignite
Barbecue temperature too low
Strong flare-up
Deflagration or bubbling noise
Potential cause
Leak in the gas system
Gas cylinder is empty
Cylinder valve is closed
The nozzle on the adjusting ele-
ment (behind front panel) is not
inserted into the burner hose.
The igniter cable is not connected
to the Piezo igniter
Distance between the spark plug
and gas outlets on the burner is
incorrect
Nozzle on adjusting
(underneath front panel)
blocked.
Other gas system blocked
Pre-heating time too short
Gas outlets on the burner are
blocked
Fatty foods
Flashback caused by blockages in
the burner.
Remedy
1. Close the cylinder valve imme-
diately (turn G1 clockwise).
2. Prevent any flame or spark for-
mation (do not switch on any
electrical appliances)
3. Tighten all connections on the
gas system
4. Check all components of the
gas system for visible damage;
replace defective parts with ori-
ginal spare parts
5. Check for leaks using a leak
detector
Replace the gas cylinder
Open the cylinder valve (turn G1
anti-clockwise).
Visual test, if necessary adjust noz-
zle and connection hose.
Conduct a visual test, connect if
necessary
Visual inspection; correct if neces-
sary
element Clean the adjuster jet with a need-
is le
The gas system should be cleaned
by a specialist
Grill unit coverClose the lid and set
the flame regulator to max
Remove blockage from burner
Remove any large areas of fat pri-
or to barbecuing or place the meat
on a grill plate or reduce the bar-
becue temperature
1. Close the cylinder valve imme-
diately (turn G1 clockwise).
2. Wait three minutes and then
switch the barbecue back on
3. If the malfunction reoccurs,
disassemble and clean the bur-
ner
13