Paper Alignment At The Registration Roller - Toshiba e-STUDIO205L Service Handbook

Hide thumbs Also See for e-STUDIO205L:

Table of Contents

Paper alignment at the registration roller

The aligning amount is adjusted by using the following codes in Adjustment Mode (05).

(*1) 0: Long size 1: Middle size 2: Short size

(*2) 0: Long size 1: Middle size 2: Short size 3: Post card

(*3) 0: Long size of OHP film 1: Middle size of OHP film 2: Short size of OHP film

1. Long size: 330 mm or longer (13.0 inches or longer)

Middle size: 220-239 mm (8.7-12.9 inches)

Short size: 219 mm or shorter (8.6 inches or shorter)

2. The adjustment of "Post card" is for Japan only.

Perform the test print according to the following procedure.

Stores in memory

(*4) 1: Single-sided grid pattern 3: Double-sided grid pattern

Check if any transfer void is occurring. If

there is a transfer problem, try the values in

descending order as "31"

until the transfer void disappears. At the

same time, confirm if any paper jam occurs.

Also, when the aligning amount has been

increased, this may increase the scraping

noise caused by the paper and the Mylar

sheet as it is transported by the registration

roller. If this scraping noise is annoying, try to

decrease the value.

Perform the same procedure for all paper sources.

e-STUDIO205L/255/305/355/455

(Not necessary for LCF)

Current value

(Test print)

Transfer void

Show Quick Links

Table of Contents