Summary of Contents for C & K Systems Securit 700L
- Page 1 This manual is from http://groups.msn.com/UKSecurityPanels Technical Manuals Online! - http://www.tech-man.com...
- Page 2 This manual will give you all the information you need to operate and control the Securit 700L Control Panel. This manual will NOT tell you how to program or configure the control panel, for that see the engineering instructions. 1.0 SETTING 1.1 FULL SET ( Used when leaving premises )
- Page 3 http://groups.msn.com/UKSecurityPanels rejected. You must then re-enter the "*" if needed. If option 7 5 has been enabled by your installer you can also manually isolate the entry exit zone in part set. 2.0 UNSETTING ( Used to dis-arm the control panel ) Enter by the specified route, the buzzer will sound, do not stop go directly to the control panel.
- Page 4 4.0 USER OPTIONS 4.1 CHANGING ZONES ON CHIME "CHIME" is a facility to make particular zones chime when triggered. For example, you could have a front door chime when opened or a room with valuables in chime when entered. Chime is only active when the panel is UNSET.
- Page 5 If your new code is allowed an accept tone will be given. If the new code is barred an error tone will be given and your old code will still be valid. Start again and enter a different four digit code. To remove or disable a second user code enter the four digit user code, the buzzer will emit a steady sound and the exit time start.
- Page 6 time start. Press the * key followed by the 9 key, then press the 4 key. The buzzerwill emit a low level steady tone. As you test each device the internal sounder will give a loud pulsing tone to indicate the correct operation of that device. The zone number LED will light. When the device tested clears the sounder will stop and the zone LED will go out.
Need help?
Do you have a question about the Securit 700L and is the answer not in the manual?
Questions and answers
How do I change my user code
To change the user code on a C & K Systems Securit 700L:
1. Enter the current four-digit user code.
2. The buzzer will emit a steady sound, and the exit time will start.
3. Press the * key followed by the 9 key.
4. Press the key corresponding to the user code to be changed:
- Press 1 to change the Master user code.
- Press 2 to change the Second user code.
5. Follow the prompts to complete the code change process.
This answer is automatically generated
How to clean keypad on C&k securitech alarm
bought a house with securitech 700L with no code, how do change the code if i dont have the original code