Electrical Connection - Currys Essentials CFSE10WH Instruction & Installation Manual

Electrical Connection

Electric cookers come without a power supply cable. The cooker is designed to operate on an electricity supply
which conforms to the electrical data shown on the Rating Plate. The cooker can be connected to the mains only
after you complete the connection at the junction box.
The following installation procedure must be carried out by a competent person. If in doubt consult a
qualified electrician. The electrical installation must comply with the IEE Regulations, Building & local By
Laws.
For the installation of the supply cable carry out the following operations:
• Release both clips then open the junction block lid.
Brown Cable
(Live –L–)
Jumper
Colours of the wires in the mains lead should correspond with the markings (on the outside of the terminal box)
identifying the terminals, proceed as follows:
Ensure all screws are adequately tightened. Do not over tighten as you may
risk damaging the screw threads.
The jumpers must be in the positions shown in the diagram to the right
otherwise the cooker may not function correctly.
Green & Yellow wire to terminal marked
Brown wire to terminal marked "L" .
Blue wire to terminal marked "N" .
• Fix the supply cable in the cable clamp, tighten the cable clamp screw and
close the cover.
• The power supply cable must have these minimum requirements:
- Type:
- Section: 3 core x 4 mm
• This appliance must be earthed.
• The cooker must be connected to the mains supply with a
switched (double pole) cooker outlet providing full disconnection
correctly fused with a capacity appropriate to that shown on
the cooker Rating Plate and incorporated in the fixed wiring in
accordance with the latest wiring regulations. All electrical wiring
from the consumer unit to the cooker, via the switched double
pole cooker outlet, must be of the correct rating.
• The supply cable must be positioned away from any hot parts
of the rear of the cooker. If this cannot be done then another
method of protecting the supply cable from the hot parts must
be used i.e. Heat resistant sleeving or high temperature cables.
16
CFSE10WH_SV_final110426_flo.indd 16
Clips of
Junction Box
Blue Cable (Neutral –N–)
Green and Yellow Cable
(Earth Connection –E–)
Cable clamp screw
.
H05VV-F (PVC insulated and sheathed flexible cable)
2
The wires in the mains lead are coloured
in accordance with the following code:
• Green & Yellow — Earth
• Blue — Neutral
• Brown — Live
Jumpers
Live
Neutral
Earth
Hot
Area
26/04/2011 7:35 PM