Adjusting The Feet; Connecting To The Drain; Electrical Connection - Beko EV7100 User Manual

A
WARNING
Models with a single water inlet should not be connected
to the hot water tap. In such a case the laundry will get
damaged or the product will switch to protection mode
and will not operate.
Do not use old or used water inlet hoses on the new
product. It may cause stains on your laundry.
Connect the special hoses supplied with the product
to the water inlets on the product. Red hose (left)
(max. 90 ºC) is for hot water inlet, blue hose (right)
(max. 25 ºC) is for cold water inlet.
A
WARNING
Ensure that the cold and hot water connections are
made correctly when installing the product. Otherwise,
your laundry will come out hot at the end of the washing
process and wear out.
Tighten all hose nuts by hand. Never use a wrench
when tightening the nuts. Open the taps completely
after making the hose connection to check for water
leaks at the connection points. If any leaks occur, turn
off the tap and remove the nut. Retighten the nut
carefully after checking the seal. To prevent water
leakages and damages caused by them, keep the
taps closed when the machine is not in use.

2.5 Connecting to the drain

• The end of the drain hose must be directly
connected to the wastewater drain or to the
washbasin.
A
WARNING
Do not remove the transportation locks before taking out
the packaging reinforcement.
• The hose should be attached to a height of at least
40 cm, and 100 cm at most.
• In case the hose is elevated after laying it on the
floor level or close to the ground (less than 40 cm
above the ground), water discharge becomes more
difficult and the laundry may come out excessively
wet. Therefore, follow the heights described in the
figure.
6 / EN
• To prevent flowing of dirty water back into the
machine and to allow for easy discharge, do not
immerse the hose end into the dirty water or do
not drive it in the drain more than 15 cm. If it is too
long, cut it short.
• The end of the hose should not be bent, it should
not be stepped on and the hose must not be
pinched between the drain and the machine.
• If the length of the hose is too short, use it by
adding an original extension hose. Length of
the hose may not be longer than 3.2 m. To avoid
water leak failures, the connection between the
extension hose and the drain hose of the product
must be fitted well with an appropriate clamp as
not to come off and leak.

2.6 Adjusting the feet

A
WARNING
In order to ensure that the product operates more silently
and vibration-free, it must stand level and balanced
on its feet. Balance the machine by adjusting the feet.
Otherwise, the product may move from its place and
cause crushing and vibration problems.
Loosen the lock nuts on the feet by hand. Adjust
the feet until the product stands level and balanced.
Tighten all lock nuts again by hand.
A
WARNING
Do not use any tools to loosen the lock nuts. Otherwise,
they will get damaged.

2.7 Electrical connection

Connect the product to a grounded outlet protected
by a fuse complying with the values in the "Technical
specifications" table. Our company shall not be liable
for any damages that will arise when the product is
used without grounding in accordance with the local
regulations.
Washing Machine / User's Manual