Power Connection; Rain Sensor Installation (Optional) - Toro 53805 Installation & Programming Manual

Power Connection

Step 1 – Remove the controller's lower panel cover
to access the power supply terminals.
Step 2 – Connect the plug -in transformer cables to the
terminals labeled "
Step 3 – Replace the lower panel cover, making sure that
the transformer cable is routed through the
provided opening at the bottom of the controller.
Step 4 – Plug the transformer into a 120 VAC, 60Hz
wall outlet.

Rain Sensor Installation (Optional)

IMPORTANT!
If a rain sensor is not connected, the sensor switch must be in the "OFF" position or the
jumper wire must be installed.
Step 1 – Remove the controller's lower panel cover
to access the sensor terminals.
Step 2 – Route the rain sensor's cable to the controller.
Step 3 – Remove the jumper cable from the "RS1" and
"RS2" terminals. Connect the sensor cables to
the terminals.
Step 4 – Replace the lower panel cover.
Step 5 – Place the "SENSOR" switch to "ON" to
monitor the sensor status.

Downloaded from www.Manualslib.com
AC1
" and
Polarity is not observed in this connection.
The sensor circuit is designed for a
manuals search engine
AC2
".
NORMALLY-CLOSED
lawn
master
SENSOR
ON
OFF
PRG
RS1 RS2 AC1 AC2 COM MV S1 S2 S3 S4 S5 S6
lawn
master
rain sensor.
SENSOR
ON
OFF
PRG
RS1 RS2 AC1 AC2 COM MV S1 S2 S3 S4
SENSOR
ON
OFF
Questions?
Call the Toro Helpline
(800) 367-8676
www.toro.com
9-Volt
Battery
Questions?
Call the Toro Helpline
(800) 367-8676
www.toro.com
9-Volt
Battery
S5 S6