Operating Limits; Engine Start And Operation - Rotax 125 MAX DD2 evo Installation Instructions And Operators Manual

5.

Operating limits

min. coolant temperature [°C / °F]
max. coolant temperature [°C / °F]
 Warning: The engine is only allowed to be run at peak performance after reaching the
specified operating temperature. Operating the engine at too low a
temperature could result in piston seizure.
 Note: If the engine does not reach the minimum specified operating temperature due to the
low ambient temperature, then the cooling efficiency of the radiator must be reduced
by partially covering the radiator with adhesive tape.
 Warning: The maximum operating temperature of the engine must not be exceeded. If
the temperature is too high, it may result in piston seizure.
 Note:
Dirt must be cleared from the lamination of the radiator at regular intervals to
achieve the best cooling performance.
6.

Engine start and operation

6.1. Engine start and operation
Prior to engine start, verify the following:
Fuel tank full.

Battery charged and connected.

Battery voltage over 12V

Carburetor Bowden cable is moving freely and carburetor piston connected in idle

position.
Shifting device in "Neutral" (no gear engaged)

At engine start proceed as follows:
 On a cold engine pull the choke lever (pos. 1, fig. 6) into a vertical position.
Seite/page 90/98
Operators Manual 125 MAX DD2 evo
35 / 95
85 / 185
Fig. 6
Ausgabe/edition 11/2014