GE JSP26 Use And Care Manual page 26

OPERATING THE SELF-CLEANING OVEN
After Self-Cleaning
You may notice some white ash in the oven. Just wipe
it up with a damp cloth after the oven cools.
If white spots remain, remove them with a soap-
filled steel wool pad. Be sure to rinse thoroughly
with a vinegar and water mixture. These deposits
are usually a salt residue that cannot be removed
by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
How to Set Delay Start of Cleaning
Quick Reminder:
1. Press the CLEAN pad.
2. Press the INCREASE or DECREASE pad
until the desired Clean Time appears.
3. Press the STOP TIME pad.
4. Press the INCREASE or DECREASE pad until
the desired Stop Time appears in the display.
Delay Start is setting the oven timer to start the clean
cycle automatically at a later time than the present
time of day.
NOTE: Before beginning, make sure the oven clock
shows the correct time of day.
1. Follow the steps in the Before a Clean Cycle
section.
CLEAN
A
pad to enter Clean Time.
4. Press the STOP TIME pad. "STOP
STOP TIME" and the earliest Stop Time you
TIME
will appear in the display.
can set
The earliest Stop Time will be the Clean Time
selected plus the time of day. For example: If the
Clean Time is three hours and the time of dav is 6:00.
the Stop Time that appears in the display wifi be 9:00.
26
(continued)
If the shelves have become hard to slide. wipe the
shelf supports with cooking oil.
NOTE: No functions can be programmed before the
door automatically unlocks.
5. Press the INCREASE pad to change the Stop Time
to a later time of day if desired. For example: If
you set Stop Time at 11:00, oven will start clean
cycle at 8:00 and end at 11:00. The door latches
automatically.
The self-clean cycle will automatically begin after
"CLEAN" is displayed and the time for clean cycle
is set. The words "ON" and "LOCK" will appear
in the display when the door automatically locks.
It will not be possible to open the oven door until –
the temperature drops below the lock temperature
and the LOCK light goes off.
6. When the LOCK light is off, open the door.
NOTE:
During a delayed self-clean operation you
can find out when the oven is set to turn
CLEAN
on by pressing and holding the CLEAN
c1
pad for 3 seconds.
internal parts. This is normal and the fan may
continue to run after the oven is turned off.