1. Manuals
  2. Brands
  3. THE WORLD MODELS Manuals
  4. Toy
  5. Jeff Troy's TAMEcat EP ARF
  6. Instruction manual

THE WORLD MODELS Jeff Troy's TAMEcat EP ARF Instruction Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Jeff Troy's TAMEcat EP ARF
Requires : 4-channel radio w/ 4 micro servos,
20A Brushless ESC, 3 cells 11. 1V
2100mAh Li - Po battery & charger.
Y - harness (1), 6 - inch servo extension (1)
Wing Span
Wing Area
Flying Weight
Fuselage Length
Warning! This model is not a toy.
It is designed for maximum performance. Please seek advice if one is not familiar with this kind
of engine powered precision model. Operating this model without prior preparation may cause
injuries. Remember, safety is the most important thing. Always keep this instruction manual at
hand for quick reference.
PERFORMANCE
KM0283010
KM0283010
Outrunner Motor Included!
Max Speed 12000 rpm
Operating Power 180 W
Operating Voltage 6-12 V
Peak Current 20 A (max 15 s)
Shaft diameter 3 mm
Diameter 28 mm
Lengthe 30 mm
Outrunner Motor
*Specifications are subject to change without notice.*
THE WORLD MODELS
MANUFACTURING CO., LTD.
FACTORY PRE-FABRICATED
ALMOST-READY-TO-FLY (ARF) SERIES
MADE IN CHINA
www.theworldmodels.com
HIGH
Weight 60 g
Specifications
39.5 in / 1000 mm
273 sq in / 17.6 sq dm
24 oz / 680 g
29.0 in / 730 mm
INSTRUCTION MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Jeff Troy's TAMEcat EP ARF and is the answer not in the manual?

Questions and answers

Related Manuals for THE WORLD MODELS Jeff Troy's TAMEcat EP ARF

Summary of Contents for THE WORLD MODELS Jeff Troy's TAMEcat EP ARF

  • Page 1 Operating this model without prior preparation may cause injuries. Remember, safety is the most important thing. Always keep this instruction manual at hand for quick reference. THE WORLD MODELS MANUFACTURING CO., LTD. FACTORY PRE-FABRICATED ALMOST-READY-TO-FLY (ARF) SERIES MADE IN CHINA www.theworldmodels.com...

  • Page 2: Before You Begin

    Jeff Troy’s TAMEcat EP ARF INDEX BEFORE YOU BEGIN PARTS LIST ASSEMBLY P.3-P.10 SAFETY PRECAUTIONS P.10 BEFORE YOU BEGIN Read through the manual before you begin, so you will have an overall idea of what to do. Check all parts. If you find any defective or missing parts contact your local dealer. Please DRY FIT and check for defects for all parts that will require CA or Epoxy for final assembly.

  • Page 3: Parts List

    Parts List 1. MAIN WING -- 1 set 9. KM0283010 OUTRUNNER MOTOR -- 1 set HW2340100 PROPELLER ADAPTOR (d3 D5) -- 1 set 2. SCREW PM2x8mm -- 4 pcs FOLDING PROPELLER SET (10x6) -- 1 set STRAPER -- 2 pcs SPINNER Ø45mm -- 1 set FUEL TUBE d2xD4x4mm -- 4 pcs COWLING --1 pc.
  • Page 4 Main Wing Apply instant type CA glue to both sides of each hinge. Aileron Servo Lead Bottom View Aileron Servos Straper PM2x8mm Screw PLYWOOD 3x7.5x17mm Fuel Tube d2xD4x4mm PM2x8mm Clevis Fuel Tube d2xD4x4mm Pushrod Ø 1.4x90mm Horn Bottom View Completed...

  • Page 5: Stabilizer & Elevator

    Stabilizer & Elevator Temporary install the main wing, adjust (Stabilizer) leveling of the stabilizer to make is as parallel to the main wing as possible. Apply instant type CA glue (Main Wing) to both sides of each hinge. *Also refer to step 13 Wing Setting Completed Vertical Fin &...

  • Page 6: Front Landing Gear

    Front Landing Gear PWA2.3x8mm Screw 2.6mm Collar Landing Wire Straps PL4114030 PWA2.3x8mm PWA2.3x8mm Bottom View Bottom View 3mm Set Screw Wheel Ø40mm 2.6mm Collar Front Completed Main Landing Gear Front PWA2.3x8mm Screw 2.6mm Collar Landing Wire Straps PWA2.3x8mm PL4114030 2.6mm Collar 2.6mm Collar 3mm Set Screw Bottom View...

  • Page 7: Elevator Pushrod

    Elevator Pushrod Ø1mm pilot holes for World Models horn are pre-drilled. PM2x8mm Screw Please look for pin-hole marks at under side of control surfaces. Straper Fuel Tube d2xD4x4mm Elevator Pushrod Pushrod Ø 1.4x120mm PM2x8mm Clevis Fuel Tube d2xD4x4mm Horn Rudder Pushrod Ø1mm pilot holes for World Models horn are pre-drilled.
  • Page 8 Outrunner Motor / Cowling PWA2x8mm Screw PM3x6mm Screw Make sure rotating motor casing is d3xD7mm Washer not in contact with wirings or anything. PA2.6x8mm Screw PM2x12mm PM3x6mm PM2x12mm Don’t over-tighten the PM2 screws, let the propeller d3xD7mm blades align themselves when spinning. Washer Ø45mm Spinner M5 Nut...
  • Page 9 d2xD5mm Balsa 3.5x45x86mm PM2x10mm Washer PM2x10mm d2xD5mm Washer Mounting Plate Balsa 3.5x45x106mm M2 Nylon Insert Lock Nut M2 Nylon Insert Lock Nut Bottom View PWA2.3x8mm Sponge 10x50x150mm Plywood 2x68.8x85mm Bottom View Main Wing PM2.5x25mm Screw d2.5xD8mm Washer Wing Protection 2x17x64mm PM2.5x25mm d2.5xD8mm Washer...
  • Page 10 Canopy PWA2x8mm Screw Pilot PWA2x8mm Wing Setting Adjust the wing and fuselage configuration as shown in the diagrams. A=A' B=B' C=C'...

  • Page 11: Control Throws

    Control Throws Adjust the control throws as shown in the diagram. These throws are good for general flying. You can adjust according to your personal preference. Rudder HIGH RATE LOW RATE Elevator 10mm HIGH RATE LOW RATE 10mm Aileron HIGH RATE LOW RATE C.G.
  • Page 12 http://www.theworldmodels.com E2450705...
  • Page 13 F-14 TAMEcat is an ideal airplane for beginners to radio control flying. The .40-size F-14 TAMEcat Trainer ARF is also available from The World Models. There are a few significant differences between that airplane and the EP version you have before you.

Table of Contents