Carburetor Installation; Air Screw Adjustment - KYMCO SUPER8 50 2T Service Manual

11.
CARBURETOR

CARBURETOR INSTALLATION

＊
When installation, do not allow foreign
particles to enter the carburetor.
Check the carburetor insulator and O-ring
for wear or damage.
Install the carburetor and insulator onto the
intake manifold and tighten the two lock
nuts.
Connect the fuel tube and auto bystarter
wire connector.
＊
Route the auto bystarter wire correctly
and properly.
Install the carburetor cap. ( 11-4)
Install the air cleaner onto the carburetor
and tighten the band screw.
Install the met-in box. ( 12 -4)

AIR SCREW ADJUSTMENT

Remove the met-in box. ( 12 -4)
＊
Warm up the engine before air screw
adjustment.
Turn the air screw clockwise until it seats
lightly and back it to the specification given.
Air Screw Opening:
Start the engine and turn the air screw in or
out slowly to obtain the highest engine
speed.
＊
Do not force the air screw against its
seat to prevent damage.
Turn the throttle stop screw to obtain the
specified idle speed.
Idle Speed:
Slightly increase the engine speed and
make sure that the engine does not miss or
run erratic.
If the adjustment of the air screw within the
range of ±½ turn makes no difference to the
engine performance, check other related
items.
11-11
: 1¼ ± ½ turns
: 1950±100rpm
Insulator
Fuel Tube
Air Screw
Throttle Stop Screw
SUPER8 50 2T
O-rings
Carburetor Cap
Air Cleaner