Choke Knob For Pull Type; Main Switch; Power Trim And Tilt Switch On Remote Control; Power Trim And Tilt Switch On Bottom Cowling - Yamaha 115C Owner's Manual

Components
1. Cord
2. Clip
3. Engine shut-off switch
EMU26012

Choke knob for pull type

To supply the engine with the rich fuel mix-
ture required to start, pull out this knob.
EMU26091

Main switch

The main switch controls the ignition system;
its operation is described below.
" " (off)
G
With the main switch in the "
tion, the electrical circuits are off, and the key
can be removed.
" " (on)
G
With the main switch in the "
tion, the electrical circuits are on, and the key
cannot be removed.
" " (start)
G
16
With the main switch in the "
sition, the starter motor turns to start the en-
gine. When the key is released, it returns
automatically to the "
EMU32053
Power trim and tilt switch on remote
control
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pushing the switch "
outboard motor up, and then tilts it up. Push-
ing the switch "
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position. For instructions
on using the power trim and tilt switch, see
pages 40 and 42.
ZMU03903
" (off) posi-
" (on) posi-
EMU26154
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on
" (start) po-
" (on) position.
" (up) trims the
" (down) tilts the outboard