Using The Multiflight Stick; Multiflight Simulator - Multiplex Profi TX Operating Instructions Manual

Operating the transmitter using the PC
6.5.2
6.5.3
PROFI TX

Using the MULTIFlight stick

Insert the MULTIFlight stick in a free USB socket on your PC. Wait until the driver
installation process, which starts automatically, is completed.
Now, you have to bind stick and transmitter. Press and hold the MULTIFlight stick
button until the yellow LED starts to flash. Switch on the transmitter. Open the
Setup > M-LINK menu. Activate the binding as described on page 95.
The binding procedure has completed successfully when the LED on the
MULTIFlight stick flashes slowly in regular intervals.
If you are using our MULTIFlight simulator, no further steps are required.
Calibration and assignment of the control channels match automatically. The
binding procedure can also be activated from the MULTIFlight simulator.
For other simulators, you may have to perform a calibration and assign the control
functions.

MULTIFlight simulator

The simulator is available as freeware download on our website:
www.multiplex-rc.de
There are 2 options available for configuring the PROFI TX transmitter for
simulator mode:

Would you like to use "Trim", "D/R", "Expo", "Combi-Switch" and the
"Ctrl.Mix" mixers?
Create a new model using the BASIC template (page 159) and change the
model name (page 161), e.g. to Simulator. Safety check can be
switched off.
From now on, use this model memory for simulator mode.

Would you like to use only the stick signals, like a game controller?
Open the Setup > Training menu item. Leave Training switched off
and set Mode to Student.
The MULTIFlight simulator automatically recognises the MULTIFlight stick and
PROFI TX.
If you have questions regarding the use of PROFI TX with third-party simulators,
please contact the manufacturer of the third-party simulator.
Page 181