Flywheel Installation - Husqvarna 50 Workshop Manual

Downloaded from www.Manualslib.com
6
Hold onto the flywheel and lift the saw slightly above
the work surface. Strike the tool squarely on its end
with a hammer to free the flywheel from the crank-
shaft. Remove the tool and flywheel.
The starter pawls and springs are serviceable. To
remove the starter pawls, position the flywheel with the
starter pawls down on two pieces of wood so that the
pawls are exposed. Drive out the pawl retaining pins
with a suitable drift.
Inspect the starter pawls and springs. Replace
components if necessary. Reassemble the pawls and
springs in the reverse order of disassembly. Press the
pawl retaining pins into the flywheel. Make sure that
the shoulder on the pins are flush against the flywheel
surface and that the pawls pivot freely.

Flywheel Installation

Thoroughly clean and dry the flywheel bore and the
corresponding taper on the crankshaft. On models
equipped with a removable flywheel key, replace the
key if damaged.
manuals search engine