Engine Oil Replacement And Bag Filters-Cartridge Filter Cleaning Or Replacement - Husqvarna TE 250 Workshop Manual

SETTINGS AND ADJUSTMENTS
Engine oil replacement and bag filters-cartridge filter cleaning or replace-
ment
Drain the oil with WARM ENGINE; proceed as follows:
- remove oil filler cap (2);
- even if not necessary, remove the engine guard (A);
- place an oil drain pan under the engine block;
- remove the oil drain cap (3), drain the used oil completely then clean the mag-
net on the cap;
- remove the three filters (5), (6) and (7) on the L.H. side of the engine, check O-
Rings for wear then clean filters with fuel.
A
Reassemble using the reverse procedure.
In order to replace the filter cartridge (4), unscrew the three fastening screws
then the filter cartridge cover;
- after filters replacement, reassemble the drain cap (3), the engine guard (A)
then pour the recommended oil quantity.
Reassemble, on engine L.H. side, filter (5-4) (8 Nm-0,8 Kgm-5.8 ft/lb) e (6) (25
Nm-2,55 Kgm-18.4 ft/lb) ed inferiormente il tappo (2) scarico olio (25 Nm-2,55
Kgm-18.4 ft/lb).
Be careful not to touch hot engine oil.
2
4
3
Part. N. 8000 B0148 (02-2008) D.21