Standard Accessories; Specifications - Hitachi WH 14DBDL Handling Instructions Manual

S
Small screw
Ordinary bolt
H
High tension bolt
Hm High mode
Mm Medium mode
L2 Low 2 mode
L1 Low 1 mode
MT Tightening torque (Maximum)
Hex. drive size
Square drive size
Weight
kg
Switching ON
Switching OFF
Disconnect the battery
Battery capacity
Light switch
Remaining battery indicator switch
Clockwise rotation
Counterclockwise rotation
High / Low mode selector switch
High / Low indicator lamp
Single / Continuous mode selector switch
Single / Continuous indicator lamp
Continuous mode
(Impact delivery will commence when the trigger
switch is pulled and impact will be applied
continuously. (The tool will not auto-stop))
Single mode
(After pulling the trigger switch, impact delivery
will commence and then auto-stop following 1
to 4 impacts.)
The battery remaining power is nearly empty.
Recharge the battery soonest possible
The battery remaining power is a half.
The battery remaining power is enough.

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 9.
Standard accessories are subject to change without notice.
APPLICATIONS
<WH14DBDL / WH18DBDL>
○ Driving and removing of machine screws, wood screws,
tapping screws, etc.
<WR14DBDL / WR18DBDL>
○ Tightening and loosening of all types of bolts and nuts,
used for securing structural items

SPECIFICATIONS

The specifi cations of this machine are listed in the Table on
page 9.
NOTE
Due to HITACHI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect to the power source. (Fig. 2)
When charging the battery from an AC power source
○ Connect the charger's power cord to the receptacle.
<UC18YFSL, UC18YML2>
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1-second intervals).
<UC18YSL3>
When connecting the plug of the charger to a receptacle,
the charge indicator lamp will blink in red (At 1-second
intervals).
CAUTION
Do not use the electrical cord if damaged. Have it
repaired immediately.
When charging the battery from a DC 12V in-car power
source (UC18YML2)
○ Secure the battery charger in place in the car.
Use the strap supplied with the battery charger to fasten
the battery charger in place and prevent it from moving
inadvertently. (See Fig. 15)
CAUTION
Do not place the battery charger or battery under the
driver's seat. Secure the battery charger in place to
prevent it from moving inadvertently as this may lead to
an accident.
○ Insert the cigarette lighter connecting plug into the
cigarette lighter socket.
If the plug is loose and falls out of the cigarette lighter
socket, repair the socket. As the socket may be faulty,
you are recommended to contact your local car dealer.
Continued use of the socket may result in an accident
due to overheating.
2. Insert the battery into the charger. (Fig. 2)
Firmly insert the battery into the charger.
5
Fig. 15