Connecting To An Antenna Or Cable Connection - Samsung 7000 series User Manual

Hide thumbs Also See for 7000 series:

Programming manual (487 pages)

User manual (193 pages)

System administration manual (46 pages)

Table Of Contents

Table of Contents

Available languages

Initial Pairing

1. When the user inserts batteries into the QWERTY Remote, "NEED PAIRING PRESS SYM+TAB" will be displayed on the

screen.

2. Press the

SYM

and

✎

The TV can be paired with only one QWERTY remote. Start the pairing process approximately 30 seconds after turning

on the TV.

✎

Keep within 20 inches(50 cm) between the QWERTY Remote and the TV.

Performing the Pairing Process Again

1. If the QWERTY Remote has been paired before, press @ and ← on the QWERTY side for more than 3 seconds.

"RESET OK" will be displayed on the LCD screen of the QWERTY remote.

2. Press MUTE, 0,

MUTE

completed within 4 seconds.

✎

There might be a slight delay between input and the response from the OSD. Do not wait for visual confirmation on the

screen.

3. Follow the initial pairing process within 3 minutes. If the initial pairing process does not finish within 3 minutes, the whole

process must be performed again.

Connecting the power cord and an antenna or cable connection

✎

When you move or swivel the TV with Antenna cable tightly connected, there is high risk antenna jack on TV will be

broken off.

Cable

ANT OUT

✎

For the best cable connections to this product, be sure to use cables no thicker than 0.55 inches (14mm).

[UD7000-NA]BN68-03435E-01L03.indb 10

TAB

buttons at the same time for more than 2 seconds.

and 0 on the remote side of the QWERTY Remote as it faces the TV. This sequence must be