Kenwood KDC-BT600U Instruction Manual page 14

BLUETOOTH®
Improve the voice quality
While talking on the phone...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following
table), then press the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
MIC GAIN –10 — +10 (–4): The sensitivity of the microphone increases as
the number increased.
NR LEVEL –5 — +5 (0): Adjust the noise reduction level until the least noise is
being heard during a phone conversation.
ECHO CANCEL –5 — +5 (0): Adjust the echo cancellation delay time until the least
echo is being heard during a phone conversation.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select an item (see the following
table), then press the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
14
SETTINGS
AUTO ANSWER
BATT/SIGNAL*
.
Default: XX
* Functionality depends on the type of the phone used.
Make a call
You can make a call from the call history, phonebook, or dialing the number.
Call by voice is also possible if your mobile phone has the feature.
1
Press
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step
instructions stated on the selected item.
4
Press and hold
To return to the previous setting item, press
CALL HISTORY
.
1 — 30: The unit answers incoming call automatically in the selected time
(in seconds). ; OFF: Cancels.
(For )
AUTO: Shows the strength of the battery and signal when the unit detects a
Bluetooth device and the Bluetooth device is connected. ; OFF: Cancels. Clock
time is shown.
to enter Bluetooth mode.
2
until the desired item is selected/activated or follow the
to exit.
(Applicable only if the phone supports PBAP)
1 Press the volume knob to select a name or a phone number.
• : "INCOMING", "OUTGOING", or "MISSED" is shown on
the lower part of the display to indicate the previous call status.
: "I" indicates call received, "O" indicates call made,
"M" indicates call missed.
• Press DISP to change the display category (NUMBER or NAME).
• "NO DATA" appears if there is no recorded call history.
2 Press the volume knob to call.
Default: XX
.