Temporis Ip300 Installation - Alcatel Temporis IP100 Administration And Provisioning Manual

Temporis IP300 installation

To install the phone:
1. If you plan to place the phone on a flat surface, you can use one of the two available
positions depending on the work angle you wish to have. To assemble the stand line
up the tabs on the stand (marked with lozenges) with the slots on the rear of the
phone as shown in the picture
Plug the end of the coiled handset cord into the Handset jack at the back of the
phone.
2. Plug one end of the Ethernet cable into the Ethernet port at the back of the console,
and plug the other end of the cable into your network router or switch.
NOTE: You may need to use a network switch connected to your router if your router
does not have sufficient ports for the number of phones you want to install. If you use
a network switch, connect the phone to the switch instead of the router in the
3. If the deskset is not using power from a PoE-capable network router or switch:
a. Connect the power adapter to the deskset power jack.
b. Plug the power adapter into an electrical outlet not controlled by a wall
switch.
Business IP Range Administration and Provisioning Guide
previous step.
ed 1.0 24/175