Projecting An Image (Basic Operation); Turning On The Projector - NEC LT280 User Manual

3. Projecting an Image (Basic Operation)

This section describes how to turn on the projector and to project a picture onto the screen.

Turning on the Projector

NOTE:
• The projector has two power switches: a main power switch and a POWER (ON/STAND BY) button (POWER ON and OFF on the
remote control).
• When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off ( )
position. Failure to do so may cause damage to the projector.
• The projector has a feature to prevent itself from being used by unauthorized individuals. To use this feature, register a keyword.
( page 42)
1. To turn on the main power to the projector, press the
Main Power switch to the on position ( I ).
• The POWER indicator will light orange.
See the Power Indicator section on page
details.
2. Remove the lens cap.
3. Press the POWER (ON/STAND BY) button on the pro-
jector cabinet or POWER ON button on the remote
control for a minimum of 2 seconds when the power
indicator turns a steady green, and the projector is
ready to use.
• After you turn on your projector, ensure that the computer
or video source is turned on and that your lens cap is
removed.
NOTE: When no signal is available, a blue, black or logo screen is displayed.
107 for more
AUTO ADJUST
3D REFORM
Standby
LAMP
STATUS
POWER
Steady orange
light
( page 107)
24
PC US B
CA
RD
CO
M PO
NE
NT LA N
IN
Y
S- VI
DE
O IN
Cb
VI DE /P b
O IN AU
DI O CO
Cr /P IN M PU
r TE R
L/M AU
ON DI O 3 IN
O CO M PU
TE R
R 1 IN
AU
DI O
OU
T
CO
M ON M PU
IT OR TE R
OU T 2 IN
PC
CO
NT
RO
L
A C
IN
PC CARD
LAMP
STATUS
ON/STAND BY POWER
SOURCE
Blinking for
one minute
LAMP
STATUS
POWER
ON/STAND BY
Blinking green
light
Press this button for a
minimum of 2 seconds.
PC CARD
LAMP
STATUS
POWER
POWER POWER
ON
OFF
COMPUTER
1 2
VIDEO VIEWER
COMPONENT
3
S-VIDEO
LAN
SELECT
Power On
LAMP
STATUS
POWER
Steady green
light