NEC TheaterSync Video Processor User Manual page 20

MKT-0026-UMN-1.002F
Output Mode
VGA 60 Hz (640 x 480)
VGA 50 Hz (640 x 480)
848 x 480 60 Hz
SVGA 60 Hz (800 x 600)
SVGA 50 Hz (800 x 600)
720p 60 Hz (1280 x 720)
720p 50 Hz (1280 x 720)
XGA 72 Hz (1024 x 768)
XGA 60 Hz (1024 x 768)
XGA 50 Hz (1024 x 768)
1360 x 768 60 Hz
1365 x 768 60 Hz
1400 x 788 60 Hz
SXGA 60 Hz (1280 x 1024)
SXGA 50 Hz (1280 x 1024)
SXGA+ 60 Hz (1400 x 1050)
SXGA+ 50 Hz (1400 x 1050)
1080p 60 Hz (1920 x 1080)
1080p 50 Hz (1920 x 1080)
1080p 48 Hz (1920 x 1080)
QXGA 60 Hz (2048 x 1536)
QXGA 50 Hz (2048 x 1536)
QXGA 48 Hz (2048 x 1536)
On entry to setup mode, the 24 x 2 LCD display indicates the following:
THEATERSYNC
Setup
Select the Menu key on your IR Remote to bring up the Setup Menu on the 24 x 2 LCD display.
The LCD display will indicate the following:
"Parameter" = ???
Setup Mode
Using the Up and Down navigation keys on the remote, you can select the next parameter in a
circular list of parameters. Using the Left and Right navigation keys on the remote, you can
select the value of the parameter. In some cases, the parameter is visible in the setup menu, but
may not be altered (such as Serial Number or MAC Address).
Selection of IP addresses is slightly different. IP addresses may only be selected if the DHCP
parameter has been set to "Off". In this case, you use the Left or Right navigation key to "enter"
the IP address. The Left key will highlight the rightmost octet; the Right key will select the
Page 20
Table 2: TheaterSync Output Modes
Comments
VESA Standard
VESA Standard
/
VESA Standard
VESA Standard
SMPTE Standard
SMPTE Standard
VESA Standard
VESA Standard
VESA Standard
/
/
/
VESA Standard
VESA Standard
VESA Standard
VESA Standard
SMPTE Standard
SMPTE Standard
SMPTE Standard
/
/
/
TheaterSync Video Processor User Manual
NEC Solutions, Inc.