Whirlpool 8LIECH-SCSSFP5W User Manual page 8

Initial Set Up
Do NOT plug in until steps 1-3 are completed.
WARNING
Electrical shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
1. If unit was transported on its side, make sure unit is in the OFF
position and is upright for at least 4 hours prior to plugging the unit in.
2. This model uses a pump to deliver water from the bottle to the reservoirs:
i. Clean the bottle cap and neck.
ii. Remove the entire plastic cap from the bottle.
iii. Adjust the length of the probe by pulling the B portion of the tube to
its maximum extension. Insert the probe into the bottle and push it
down. The probe will self-adjust to its appropriate length. (See
illustration on right).
iv. Push down the probe head until it is seated.
v. Plug power cord into the wall outlet.
Note: At initial set-up, it will take less than 3 minutes to fill reservoirs with
water. If pump stops prematurely, please open and close the door to
activate reset using door switch.
NOTE: When using a 5 gallon rectangular bottle, slide it into place as shown in the illustration
below.
• If the probe tube A and B are not sealed(see previous page), the pump will run a few minutes
and the night lights will flash. To correct, open the door, re-attach the probe, and close the
door.
• If the lights continue to flash, your bottle may be empty or there may be an issue with the water
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
Model # 8LIECH-SCSSFP5W: Page 8
WARNING
Excessive Weight Hazard
Use two or more people to move and install the
water cooler and the bottles.
Failure to do so can result in back or other injury.
Stainless Steel
A
tube for Self - Clean
function
Expandable telescopic
tube for drawing water
B
from the bottle