GSM Gateway rl300 user manual rev 1.0 SAGEM RL300 is a convenient GSM gateway used to connect phone to access GSM network plugging your phone on the device will allow you to: -send and receive voice calls, -send and receive SMS*...
Page 2
Plug your telephone set and power up rl300 This led will switch on Enter pin code Pin is requested if led is blinking slowly and dial tone is high with interruptions This is needed only once while the card is not changed...
Page 3
If voicemail led is blinking, call the 5500 to listen to your messages. During the call the led will be switched off. RL300 supports SMS sending and receiving.*please check your phone manual to check if it supported and usage instructions...
Configuration To do only if your phone behave differently than usual. ● end of dialing timeout *5*005*TT# TT is a value is seconds between 1 and 30 (default 4) ● flash signal duration (r key config ) Minimum value: *5*014*min# Min is a value in 10 milliseconds between 4 and 55 (default is 7) Maximum value: *5*015*max#...
Wait for confirmation tone Safety notes General: please read this manual carefully before using the device. Do not install your rl300 in a humid room (bathroom, laundry, kitchen, etc.), or within 1.50 m of a tap or water source, or outside.
Need help?
Do you have a question about the rl300 and is the answer not in the manual?
Questions and answers