Table of Contents
Advertisement
INSTALLATION
Moving and Installing
Removing the Transit Bolts
Four transit bolts keep the interior of the washing machine in place while it's being moved.
They need to be removed before installation. Use a spanner (not supplied) and follow the
instructions detailed below.
Don't run the washing machine without removing the transit bolts, as this can
cause excessive vibrations and may damage your machine.
To remove the transit bolts:
1. Use a spanner to loosen the four bolts. They are located at the rear of the washing
machine.
2. Pull the bolts out horizontally. Make sure the entire bolt is removed.
3. Push the four cover caps (included with your accessories) into the respective bolt holes.
You'll need the transit bolts again if you move the washing machine, so make sure
you keep them in a safe place.
Moving the Washing Machine from One Location to Another
Before you move the washing machine:
•
Shut off the tap and run the washing machine to drain the water. Drain any remaining
water from the pump hose.
•
Disconnect the mains cable.
•
Attach the transit bolts.
Make sure to fix the transit bolts prior to moving the washing machine.
8
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the L712WM13 and is the answer not in the manual?
Questions and answers
How do I do a drum clean Do 8 just press the drum clean button Do I add any detergent
To clean the drum of the Logik L712WM13, ensure the washing machine is unplugged. Remove any rust inside the drum using a chlorine-free detergent. Do not use steel wool. Do not place laundry inside the drum during cleaning. The information does not specify whether to add detergent, but using a chlorine-free detergent for rust removal is mentioned.
This answer is automatically generated
what setting for drum clean