Motor Unit With Multi-Sander Attachment Pkga2; Motor Unit With Sabre Saw Attachment Pkga3 - Parkside PKGA 14.4 A1 Original Instructions Manual

GB IE CY
3. Start with a lower torque step and in-
crease as required.
The direction change may only be
actuated when the appliance is at a
standstill!
The necessary torque is dependent
on:
- the type and hardness of the ma-
terial to be treated;
- the type and length of the screws
used.
Motor unit with multi-sander
attachment PKGA2
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
Attaching/removing sanding
sheet
The sanding plate (
Velcro for rapid attachment of the sanding
sheet.
Attaching sanding sheet
1. Press the sanding sheet (24)
evenly onto the sanding plate
(22). Ensure that the holes in the
sanding sheet are placed above
the openings in the sanding
plate.
Removing sanding sheet
2. Simply pull the sanding sheet
(24) off the sanding plate (22).
16
22) is fitted with
Connecting dust extraction
You can reduce dust production during
sanding by attaching a dust extraction
system.
1. Push the adaptor (25) into the
opening on the multi-sander at-
tachment (23) as far as the stop.
2. Connect a dust extractor suction
hose to the adaptor (25).
Motor unit with sabre saw
attachment PKGA3
Installing/changing the blade
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
Wear gloves when handling the
sawblade. In this way, you avoid
injury from cuts.
Caution, risk of Injury!
- Do not use any blunt or bent
blades or blades which are
damaged in any other way.
- Always insert a suitable saw-
blade.
An overview of appropriate blades
can be found in "Spare Parts/Ac-
cessories".
Installing the blade:
1. Push the lever (19) for sawblade
unlocking upwards as far as
the stop. Push the sawblade
shaft (20/21) into the sawblade
mounting slot.