Quick Start - Ateme Kyrion CM5000 User Manual

• After a few seconds, a BOOTING message should appear on the LCD.
• The front panel selection menu appears when the unit is up and running.

3.2. Quick start

Step 1 : Configure management IP address
Use the front panel to configure the MGT IP address of the encoder: [Kyrion IP address] (System ->
Network -> MGT -> IP).
Step 2 : Open a web browser
On a computer connected to the same network, launch your favourite web browser and browse to http://
[Kyrion IP address].
Step 3 : Login
An authentication popup may appear. In this case, type 'admin' as username and 'admin' as password
(default login).
Step 4 : Configure the encoder
Go to the Channel 1 tab, configure the TS bitrate, the video format and an output, click on 'Apply'.
Step 5 : Start the encoder
Go to the Status tab, click on 'Start'.
www.ateme.com
CM5000 users' manual UM-CM5000-FW1.1-REV1.0
2012-10-30
Page 23