Connections; Connecting To A Tv - NAD T 513 Owner's Manual

• Depending on your TV and other equipment you wish to connect,
there are various ways you could connect the player. Use only one of
the connections described below.
• Please refer to the manuals of your TV, VCR, Stereo System or other
devices as necessary to make the best connections.
• For better sound reproduction, connect the player's AUDIO OUT
connectors to the audio in connectors of your amplifier, receiver,
stereo or audio/video equipment. See "Connecting to Optional
Equipment" on page 10.
CAUTION
• Make sure the DVD Player is connected directly to the TV. Tune the
TV to the correct video input channel.
• Do not connect the DVD Player's AUDIO OUT jack to the phono in
jack (record deck) of your audio system.
• Do not connect your DVD Player via your VCR. The DVD image could
be distorted by the copy protection system.

CONNECTING TO A TV

• Make one of the following connections, depending on the
capabilities of your existing equipment.
VIDEO CONNECTION
1 Connect the VIDEO OUT jack on the DVD Player to the video in jack
on the TV using the video cable (V).
2 Connect the Left and Right AUDIO OUT connectors of the DVD
Player to the audio left/right in connectors on the TV using the audio
cables (A).
S-VIDEO CONNECTION
1 Connect the S-VIDEO OUT jack on the DVD Player to the S-Video in
jack on the TV using the S-Video cable (S).
2 Connect the Left and Right AUDIO OUT connectors of the DVD
Player to the audio left/right in connectors on the TV using the audio
cables (A).
COMPONENT VIDEO (COLOR STREAM®) CONNECTION
1 Connect the COMPONENT VIDEO OUT/ PROGRESSIVE SCAN
connectors on the DVD Player to the corresponding in connectors on
the TV using an Y / Pb / Pr cable (C).
2 Connect the Left and Right AUDIO OUT connectors of the DVD
Player to the audio left/right in connectors on the TV using the audio
cables (A).
PROGRESSIVE SCAN CONNECTION
• If your television is a high-definition or "digital ready" television, you
may take advantage of the DVD Player's progressive scan output for
the highest video resolution possible.
• If your TV does not accept the Progressive Scan format, the picture
will appear scrambled if you try Progressive Scan on the DVD Player.
1 Connect the COMPONENT VIDEO OUT/ PROGRESSIVE SCAN
connectors on the DVD Player to the corresponding in connectors on
the TV using an optional Y Pb Pr cable (C).
2 Connect the Left and Right AUDIO OUT connectors of the DVD Player
to the audio left/right in connectors on the TV using the supplied
audio cables (A).
NOTES
• Set the Progressive to "On" on the setup menu for progressive
signal, see page 13.
• Progressive scan does not work with the analog video connections
(yellow VIDEO OUT jack).
Rear of TV
Introduction

CONNECTIONS

Rear of DVD player
9