Murphy Pull/Push DC Solenoids RP2307B Owner's Manual

Pull/Push DC Solenoids for
Diesel Engines
RP2309B & RP2310B
RP2307B & RP2308B
Description
Murphy push/pull DC Solenoids
provide single unit versatility for engine
applications, such as shutdown.
A choice of two models and two
voltages is available. All models come
complete with return spring and rubber
seal boot. See the next page for
specifications and options.
Basic Models
Models RP2307B and RP2308B give a
full one inch (25 mm) stroke at 11
pounds (49 N) and hold up to 23 pounds
(102 N) at full voltage, continuous duty.
MODEL & PART NUMBERS:
Model No.
RP2307B
RP2308B
RP2309B
RP2310B
65-01-0108
65-01-0110
40-05-0315
00-00-2457
00-00-2458
They will operate at any stroke less than
maximum; refer to the chart shown on
page 2.
Models RP2309B and RP2310B can
pull 14 pounds (62 N) with a one-and-a-
half inch (38 mm) stroke. They hold up
to 34 pounds (151 N) at full voltage,
continuous duty. See the chart on page 2
for holding force at any stroke less than
maximum.
SD85 Solenoid Drive
Time Delay
Using the SD85 ensures the energize
coil is only powered for 1-2 seconds
DC SOLENOIDS & ACCESSORIES
Description
12 VDC, 1 in. (25 mm) stroke, 11 lbf (49 N) pull, 23 lbf (102 N) hold
24 VDC, 1 in. (25 mm) stroke, 11 lbf (49 N) pull, 23 lbf (102 N) hold
12 VDC, 1-1/2 in. (38 mm) stroke, 14 lbf (62 N) pull, 34 lbf (151 N) hold
24VDC, 1-1/2 in. (38 mm) stroke, 14 lbf (62 N) pull, 34 lbf (151 N) hold
Clevis yoke assembly
Clevis yoke chain assembly
Threaded rod (1-1/2 in.)
RPS in-line ball joint
RPS 90° ball joint
RPS-00092B page 1 of 4
RP Series
■
One Solenoid For Pull/Push Operation
■
No Internal Switches
■
Reduce Coil Burnout
■
Boost Reliability
■
Reduce Adjustments
■
High Force–Small Size
■
Can Be Used With Most Engines
Start Systems
■
SD85 Solenoid Drive Time Delay
Available To Greatly Reduce Possibility
Of Coil Burnout And Facilitate Low
Current Piloted Operation.
with each operation. If the plunger does
not seat in that time, it is highly
unlikely it will seat. The hold coil is
energized as long as the signal to the
SD85 is active. This insures long life of
the RP solenoid.
Warranty
A limited warranty on materials and workmanship
is given with this FW Murphy product. A copy of
the warranty may be viewed or printed by going
to www.fwmurphy.com/support/warranty.htm
RPS-00092B
Revised 11-03
Catalog Section 40
(00-02-0107)
SHIPPING WEIGHT
ozs (kg)
24 ozs (0.7 kg)
24 ozs (0.7 kg)
48 ozs (1.4 kg)
48 ozs (1.4 kg)
1 ozs (.03 kg)
2 ozs (.04 kg)
.05 ozs (.001 kg)
.05 ozs (.001 kg)
1 ozs (.03 kg)