Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for NEC E585
Summary of Contents for NEC E585
- Page 1 User’s Manual E585 E505 E425 E325...
-
Page 2: Table Of Contents
Mobile Telephone Warning ������������������������������������������������������ English-28 End Of Life Directives�������������������������������������������������������������� English-28 Italian Homologation declaration ��������������������������������������������� English-28 Manufacturer’s Recycling and Energy Information ���������������������������� English-29 Disposing of your old NEC product ����������������������������������������� English-29 Energy Saving ������������������������������������������������������������������������� English-29 WEEE Mark (European Directive 2012/19/EU) ����������������������� English-30 Specification �������������������������������������������������������������������������������������� English-31 Product Specifications �������������������������������������������������������������... -
Page 3: Precautions And Reminders
Precautions And Reminders Do not place the display Do not open the display Call a NEC certified in confined spaces or in a cabinet� service personnel for any box when in use� Maintain internal service needed for ample ventilation for the your display�... -
Page 4: Important Safety Instructions
Important Safety Instructions Read before operating equipment Follow all warnings and instructions marked on this display� 1� Read these instructions� 2� Keep these instructions� 3� Heed all warnings� 4� Follow all instructions� 5� Do not use this apparatus near water� 6�... - Page 5 15� The display complies with the recommended safety standards for stability� Do not put excessive force on the front or top of the cabinet� This could cause the product to tip over and cause damage and/or personal injury� 16� If display or glass is broken, do not come in contact with the liquid crystal and handle with care�...
-
Page 6: Important Information
Important Information WARNING TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE� ALSO, DO NOT USE THIS UNIT’S POLARIZED PLUG WITH AN EXTENSION CORD RECEPTACLE OR OTHER OUTLETS UNLESS THE PRONGS CAN BE FULLY INSERTED� REFRAIN FROM OPENING THE CABINET AS THERE ARE HIGH VOLTAGE COMPONENTS INSIDE�... - Page 7 LCD display and call your authorized dealer or service center� Adjust only those controls that are covered in the instructions, as improper changes or modifications not expressly approved by NEC could void the user’s warranty� Batteries installed warning Incorrect usage of batteries can result in leaks or bursting�...
- Page 8 CAUTION: These servicing instructions are for use by qualified service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Ventilation The slots and openings in the display are provided for necessary ventilation�...
- Page 9 For use only with UL Listed Wall Mount Bracket with minimum weight/load: Please refer to the Specification on page 31. Unit without base weight: The equipment and its associated mounting means still remain secure during the test� Used wall mounting kit, VESA-compatible wall bracket distance, diameter of Screw dimension: Please refer to the Specification on page 31.
-
Page 10: License Notice And Trademark Acknowledgement
License Notice and Trademark Acknowledgement Windows is a registered trademark of Microsoft Corporation� NEC is a registered trademark of NEC Corporation� All other brands and product names are trademarks or registered trademarks of their respective owners� ® HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries�... -
Page 11: Declaration Of Conformity
CAN/CSA C22�2 No� 60065-03� FCC information 1� Use the attached specified cables with the E585/E505/E425/E325 color display so as not to interfere with radio and television reception� (1) Please use the supplied power cord or equivalent to ensure FCC compliance�... -
Page 12: Contents
Remote Control • 1�5V AAA Size Batteries x2 • Setup Manual x1 • CD ROM E585 / E505 / E425 / E325 Video Signal Cable (EU) (Mini D-SUB 15 pin to Power Cord* Mini D-SUB 15 pin) Setup Manual Wireless Remote Control... -
Page 13: Preparation
The manufacturer’s warranty does not cover user abuse or improper installations� Attaching the Base E585 Stand Screw x 6 E585:M4 (14mm) E505 / E425 / E325 Stand Screw x 4 E505:M6 (20mm) E425/E325:M4 (20mm) 1�... -
Page 14: Using Cable Clamper
For your safety, only mount with a UL listed wall mount bracket that supports the weight of the display� (Please see page 31�) To attach a wall mount bracket to your display: E585 E505/E425/E325 VESA Hole... -
Page 15: Prohibit Portrait Condition Use
NOTE: Wall mounting solution is not included with the unit and is sold separately� Contact your NEC representative for details� It is necessary to provide screw of appropriate length (Wall mount bracket thickness + VESA hole depth)� Prohibit portrait condition use CAUTION: Do not rotate the diplay from landscape to portrait�... -
Page 16: Place The Display On A Solid Surface
Place The Display On A Solid Surface Ensure that the LCD display is placed in a position to allow free flow of air� Do not cover the ventilation openings on the back cover� Do not place the display near any open flames. -
Page 17: Connect To The Power Source
Connect To The Power Source The display should be installed close to an easily accessible power outlet� Fully insert the prongs into the power outlet socket� A loose connection may cause image degradation� If there is power to the display, the front LED at the bottom of the display will be either none or red�... - Page 18 warming up mode� 2� In warming up mode, when the Display receives a signal from an external VGA device, it switches automatically to on mode� NOTE: Note that in warming up mode, the Display does not switch automatically to on mode even if a signal is input from an external device using HDMI, component video or composite video�...
-
Page 19: Source Connection Guide
Source Connection Guide E585 AC POWER ❶ ❷ ❸ ❻ ❺ ❹ 1� RS-232C – Connect to your PC, and receive the control commands from the PC� 2� HDMI (HDMI1, HDMI2, HDMI3) – Connect to your HDMI devices� 3� USB port – Used for accessing photo, music, and movie files. - Page 20 E505 / E425 / E325 AC POWER E325 / E425 E505 ❶ ❷ ❸ ❻ ❺ ❹ 1� RS-232C – Connect to your PC, and receive the control commands from the PC� 2� HDMI (HDMI1, HDMI2, HDMI3) – Connect to your HDMI devices� 3�...
-
Page 21: Operating Instructions
Operating Instructions Using The Side Panel Controls Press to increase the volume� 1� VOL + Press this button to shift Right in the OSD menu� Press to decrease the volume� 2� VOL - Press this button to shift Left in the OSD menu� 3�... -
Page 22: Using The Remote Control
Using The Remote Control (Power) Press to turn On/Off (standby) the power� (NOTE: To completely turn off the power, unplug the power cord from the power outlet�) No function� Press to choose Composite source mode� COMP PRE CH Press to choose Component source mode�... -
Page 23: Operating Range For The Remote Control
30° within a distance of about 3�5 m (10 ft�)� E585 / E505 / E425 / E325 CAUTION: Important, the remote control system may not function when direct sunlight or strong illumination strikes the remote control sensor or when there is an object in the path�... -
Page 24: Timing Table
Timing Table WXGA Horizontal Vertical (E325) (E585/E505/E425) Nominal Pixel Resolution Nominal Nominal Clock Sync Sync Freq. Freq. (MHz) Polarity Polarity (kHz) (Hz) 640 × 480@60Hz ● ● ● ● 31�469 – 59�94 – 25�175 720 × 400@70Hz ● ● ●... -
Page 25: Navigating The On-Screen Menu
Navigating The On-Screen Menu Press the Menu button to display and Exit to close the main menu� Use the Navigation Ring to navigate, select, adjust or confirm an item on the OSD (On Screen Display) menu� NOTE: Some features may only be available in a particular source mode� Video Menu [Noise Reduction] Set to reduce the video noise�... -
Page 26: Audio Menu
Audio Menu Setup Menu The Audio menu provides an audio According to various requirements in adjustment for user to modify the audio different source modes, certain features setting� could be hidden (disabled) on the menu� Video Menu Language English Sound Mode Standard Video Sleep Timer... - Page 27 [H-Position] 9� IR Lock Setting Adjust horizontal position� Select On to lock your remote control, and the remote control [V-Position] will disable to control the display� Adjust vertical position� Press Display button for 5 [Clock] seconds can unlock it� Set to the minimum level if noise 10�...
-
Page 28: Usb Menu
USB Menu To control while viewing photos: • Select or press button to You could browse images, listen to PLAY play image slideshow� musics, or play videos from USB device� • Select or press button to Pause pause the playing image� Video •... - Page 29 stop the playing file. CAUTION: or press Display • Select Info. • Only supports USB Mass storage button to show the playing file’s class devices� information� • A JPEG image modified with PC • Select to repeat files in the Repeat may not be displayed�...
-
Page 30: Maintenance And Recycling
Maintenance and Recycling Care Of The Screen Do not rub or strike the screen with anything hard as this may scratch, mar, or even damage the screen permanently� Unplug the power cord before cleaning the screen� Dust the display by wiping the screen and the cabinet with a soft, clean cloth�... -
Page 31: Manufacturer's Recycling And Energy Information
Dedicated recycling sites ensure that environmentally harmful components are properly handled and securely disposed� To ensure the best recycling of our products, NEC DISPLAY SOLUTIONS offers a variety of recycling procedures and gives advice on how to handle the product in an environmentally sensitive way, once it has reached the end of its life�... -
Page 32: Weee Mark (European Directive 2012/19/Eu)
This includes monitors and electrical accessories, such as signal cables or power cords� When you need to dispose of your NEC display products, please follow the guidance of your local authority, or ask the shop where you purchased the product, or if applicable, follow any agreements made between yourself and NEC�... -
Page 33: Specification
Specification Product Specifications E585 LCD Module 58”/ 1,473 mm diagonal Resolution: 1,920 x 1,080 Color: Over 16 million colors (depending on video card used) Frequency Horizontal: 31 – 83KHz (Analog input) 15�625/15�734KHz, 31 – 83KHz (HDMI input) Vertical: 60Hz – 75Hz (Analog input) 24Hz, 30Hz, 50Hz, 60Hz –... - Page 34 E505 LCD Module 50”/ 1,270 mm diagonal Resolution: 1,920 x 1,080 Color: Over 16 million colors (depending on video card used) Frequency Horizontal: 31 – 83KHz (Analog input) 15�625/15�734KHz, 31 – 83KHz (HDMI input) Vertical: 60Hz – 75Hz (Analog input) 24Hz, 30Hz, 50Hz, 60Hz –...
- Page 35 E425 LCD Module 42”/ 1,067 mm diagonal Resolution: 1,920 x 1,080 Color: Over 16 million colors (depending on video card used) Frequency Horizontal: 31 – 83KHz (Analog input) 15�625/15�734KHz, 31 – 83KHz (HDMI input) Vertical: 60Hz – 75Hz (Analog input) 24Hz, 30Hz, 50Hz, 60Hz –...
- Page 36 E325 LCD Module 32”/ 813 mm diagonal Resolution: 1,366 x 7,68 Color: Over 16 million colors (depending on video card used) Frequency Horizontal: 31 – 83KHz (Analog input) 15�625/15�734KHz, 31 – 83KHz (HDMI input) Vertical: 60Hz – 75Hz (Analog input) 24Hz, 30Hz, 50Hz, 60Hz –...
-
Page 37: Rs-232C Port Specifications
RS-232C Port Specifications PC control of the Display Attach an RS-232C cable cross-type (commercially available) to the supplied RS-232C for the connections� NOTE: This operation system should be used by a person who is accustomed to using computers� Communication procedure Send the control commands from the PC via the RS- 232C connector�... -
Page 38: Before Calling Service
Before Calling Service Please make these simple checks before calling service� These tips may save you time and money as charges for receiver installation and adjustments of customer controls are not covered under your warranty� Symptoms Items To Check And Actions To Follow •... -
Page 39: Glossary
Glossary HDMI Inputs High-Definition Multimedia Interface Audio / Video Inputs are located on the receiver� These connectors are used for the input of audio and video signals� Designed to receive higher picture resolution and offer sound connection options� Menu An on-screen listing of features shown on the display screen is made available for user adjustments�...