Management Module Configuration; Initial Setting Procedure; Login - Hitachi compute blade 500 series Getting Started Manual

Figure 2-2 Connecting the LAN cable directly to the management module
Tip: You need to connect with LAN cable when setting up the following
configurations and running the following operations.

Management module configuration

The management module is a hardware controller that manages the system
unit.Various settings need to be setup before the management module can be
used.
The initial settings described below are required:
• System administrator password
Create a new system administrator password for the management
module.
• System identification code
Set the server chassis ID.
• Network settings
Configure the network settings such as the IP address, subnet mask (the
prefix, in the case of IPv6), and default gateway.

Initial setting procedure

The following describes the initial setup procedure of the management
module in detail.

Login

1 Start a new web browser from the system console.
.
2 Enter the URL of management module web console (enter "https://
.
192.168.0.1/" when factory default setting) into the address field box of
the browser.
2-4
Initial setup
Hitachi Compute Blade 500 Series Getting Started Guide