Table of Contents
Advertisement
Available languages
Available languages
mindy A924
Contents:
1
2
2.1
2.2
2.3
2.4
2.5
2.6
2.7
3
3.1
3.2
3.3
3.4
3.5
3.6
Warnings:
This manual has been especially written for use by
!
qualified fitters. No information given in this manual can be
considered as being of interest to end users! This manual
refers to the A924 control unit and may not be used for
different products. The A924 control unit has been designed
to control the SUMO electromechanical actuator produced by
Nice s.p.a.; any other use is considered improper and is
consequently forbidden by current law. Do not install the unit
before you have read all the instructions.
4
pag.
3.7
3.8
5
5
5
4
5
6
5
6
5.1
7
8
6
9
6.1
9
7
10
10
8
10
11
9
11
12
10
12
12
13
13
14
14
15
16
17
17
17
18
18
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the Mindy A924 and is the answer not in the manual?
Questions and answers
How to program the motor limit
Programming the motor limit for the Nice Mindy A924 involves setting the mechanical stops and configuring the system to recognize the movement range. The steps include:
1. Initial Stop Search: The control panel first detects the mechanical stops to establish the movement range.
2. Encoder Calibration: The built-in encoder measures the rotation degrees to accurately position the gate.
3. Electrolock Positioning: If applicable, the electrolock position must be programmed.
4. Pause Time Configuration: A programmable pause time can be set between 1 and 1023 seconds.
5. Speed and Amperometric Regulation: The system allows speed adjustments and force regulation.
These steps ensure smooth and safe gate operation.
This answer is automatically generated
How program the limit
The Nice Mindy A924 control panel automatically memorizes the limit switches during opening and closing. However, manual programming of mechanical stops may be required. The process involves:
1. Initial Search for Mechanical Stops: Ensure the system detects the mechanical limits.
2. Electric Block Position Programming: Set the stopping points using the encoder.
3. Pause Time Adjustment: Configure the delay before reversing or stopping.
For precise steps, refer to the programming section of the manual.
This answer is automatically generated
You have video to connect all the wire and programing