MV Agusta BRUTALE 750 S Workshop Manual page 285

Insert the spacer ring illustrated in the figure onto the
wheel pin.
Insert the crown wheel assembly, the second spacer
ring and the wheel pin fixing nut.
Reassemble the chain as described at pages 57÷60 of
this chapter.
Tighten the 5 nuts to block the silentblocks as shown
in the figure.
Tightening torque: 45 ÷ 50 N·m
Tighten the 5 nuts to block the crown on the flange as
shown in the figure.
Tightening torque: 25 N·m
Apply grease only on the threaded part
Tighten the wheel pin fixing nut by rotating it clockwise
as shown in the figure, by using the following tools:
• Torque wrench
• 55 mm polygonal socket wrench
Slip flange nut coupling torque:
200-220 Nm
Apply grease only on the threaded part
Assemble the retaining ring.
Reassemble the lower chain pad, the upper chain
guard and the central exhaust manifolds respectively.
Suspension and wheels
- 71 -
45÷50 N•m
25 N•m
200÷220 N•m
F