General Operation; Preset Programmes; Central Heating - Danfoss TP9000 Installation And User Instructions Manual

General Operation

The TP9000 has two distinct display modes - one for Hot Water, one
for Central Heating. The currently selected
mode is indicated by a bar at the bottom
of the LCD screen when in run mode. The
right bar is for Heating, the left bar is for Hot
Water.
When programming the TP9000 it is
important to be aware of which mode is active before beginning
programming. To toggle between modes, press the CH/HW button.
The display will change and the indicator bar at the bottom will move
to refl ect which mode is selected. The fl ame ( ) and tap ( ) symbols
are used in conjunction with the LED's to show the current output
status (on/off ). The output status is always shown for both Heating and
Hot Water regardless of the display mode.

Preset programmes

Your TP9000 comes ready programmed with a set of operating times and
temperatures which suit most people. Please remember that some of the
options available will depend on how the installer has set up the unit.

Central Heating

Weekdays (Mon-Fri)
Event Time
1 06:30
2 08:30
3 11:30
4 13:30
5 16:30
6 22:30
Note: these are also times for
Block "A" programmes
Note: If set up for 4 events per day, events 3 & 4 are skipped. If set up
for 2 events per day, events 2, 3, 4 & 5 are skipped. In both cases the
events are re-numbered.
DANFOSS HEATING
Temp. °C Event
20
15
20
15
21
15
Note: these are also times for
Weekend (Sat-Sun)
Time
1 07:30
2 09:30
3 11:30
4 13:30
5 16:30
6 22:30
Block "B" programmes
GB
PL
Temp. °C
20
20
20
20
21
15
17