Table of Contents
Advertisement
Lubrication
Your appliance requires no additional lubrication.
Cleaning
WARNING: Never use solvents or other
harsh chemicals for cleaning the non-
metallic parts of the appliance. These
chemicals may weaken the materials
used in these parts. Never let any liquid
get inside the machine; never immerse
any part of the appliance into a liquid.
1. Vacuum the outside of the dust extractor. For
further cleaning use a cloth dampened only with
water and mild soap if necessary.
2. After use dispose of cloth in an appropriate
container.
Storage (fi g. 1)
1. Empty the canister, refer to To Empty Canister
under Operation.
2. Clean the vacuum inside and outside. Refer to
Cleaning.
3. Clean or replace filter, refer to Filter.
4. Store the suction hose and the power cord (b)
as shown in the illustration. Place the unit in a
dry room and secure it from unauthorized use.
Optional Accessories
WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this appliance
could be hazardous. To reduce the risk
of injury, only D
WALT recommended
E
accessories should be used with this
product.
ACCESSORIES
DWV9340-XJ
Filter
DWV9315-XJ
Crush-proof hose
DWV9401-XJ
Paper bag
DWV9402-XJ
Fleece bag
DWV9500-XJ
Vac Rack
DWV9000
DWV9110
DWV9120
DWV9130
DWV9150
VAC RACK DWV9500 INSTALLATION (FIG. 9)
NOTE: The DWV900LT comes with DWV9500 vac
rack attachment already installed,
1. Remove the 4 carry handle screws using a T-25
star bit and remove the carry handle.
2. Install the vac rack reusing the carry handle
screws. Put them back in their original holes
and tighten.)
3. Use the 2 screws (v) provided by placing them
in the rear holes of the vac rack. Push down
and turn each screw to break through the
material and into the hidden screw boss below.
Tighten.
WALT, have
E
SECURING THE POWER CORD TO THE HOSE (FIG. 1)
The power cord (b) can be secured to the suction
hose (g) using the D279058CL hose clip (available
from your local D
Consult your dealer for further information on the
appropriate accessories.
Troubleshooting
PROBLEM
Motor
does not
run
D
WALT AirLock System
E
Twist-Lock
connection
29-35 mm tapered
rubber adapter
35-38 mm stepped
rubber adapter
35 mm OD adapter
35 mm OD angle
adapter
CAUTION: Do not exceed 9 kg (20 lb)
in each 14 liter storage unit, maximum
2 storage units per dust extractor. Do
not exceed 18 kg (40 lb) in a 28 liter
storage unit, 1 storage unit per dust
extractor. Exceeding the recommended
height and/or weight could result in an
unstable dust extractor would could
cause injury or damage.
NOTICE: Do not remove dust extractor
head from tank with T-stack storage
units attached. Doing so could result in
damage to the dust extractor filter.
WALT supplier).
E
SOLUTION
Check power cord, plugs and outlet.
Ensure the on/off switch is in the ON
position ( ).
ENGLISH
9
Advertisement
Table of Contents
