Page 1
Installation instructions C 556 C 586 www.contura.eu...
Page 2
350° C for both top connection directly upwards and connection directly backwards from the rear of the stove. Contura 556/586 is a Swan marked stove. NIBE was the first stove manufacturer in Sweden to commit to Swan marking their stoves.
Contura stove you have secured a product with timeless design and long service life. The Contura is not only an efficient source of heat, but it is environmentally friendly as well. Read through these installation instructions carefully before installation.
556/586 FACTS Important to remember! Technical details Contura 556 Contura 586 Installation by authorised Structural support technician Check that the wood joists are strong enough to bear the weight of the stove and This manual contains instructions about chimney. The stove and chimney can usually...
556/586 REMOVAL How to remove the heat deflector How to remove the hearth surround (Vermiculite) Handle the vermiculite with care. Lift the smoke baffle with one hand whilst removing the four side parts. Reinstall in reverse order...
556/586 CHIMNEY Connection to chimney • The stove meets the requirements for connecting to chimneys • A flue with sharp bends and horizontal routing reduces the dimensioned for 350°C flue gas temperature. draught in the chimney. Maximum horizontal flue is 1 m, on the condition that the vertical flue length is at least 5 m.
556/586 SUPPLY AIR/ACCESSORY Supply of combustion air When a stove is installed in a room, the air supply demand to the room increases. Air can be provided indirectly via a vent in the outer wall or via a duct from the outside that is connected to the connector on the underneath of the stove.
556/586 Installation distances C556 The minimum distance in front of WHEN INSTALLING TURNTABLE (OPTION) the the stove opening to combustible following installation distances do not apply. parts of the building or interior See the separate turntable instructions. Combustible roof decoration must be at least 1 m. When top connecting a steel flue please refer to the relevant manufacturer’s installation...
556/586 Installation distances C586 Combustible roof WHEN INSTALLING TURNTABLE (OPTION) the The minimum distance in front of following installation distances do not apply. the stove opening to combustible See the separate turntable instructions. parts of the building or interior decoration must be at least 1 m. When top connecting a steel flue please refer to the relevant manufacturer’s installation...
556/586 Installing C556 Wait to tighten the back panel’s upper screws Clean the side glass until the side panels are installed. thoroughly before installing the side panels. Installing the rating plates C556 The following rating plates must be placed on the underneath of the heat deflector.
Page 11
556/586 READY! If the stove’s loose components are removed these must be reinstalled in reverse order when the stove is put in place. Final inspection of the installation It is extremely important that the installation is inspected by an authorised chimney sweep before the stove is used.
556/586 Installing C586 Do not tighten the screws until the stove has been raised again. Wait to tighten the back panel’s screws until the side panels are installed. Installing the rating plates C586 The following rating plates must be placed on the underneath of the pillar frame.
Page 13
556/586 Clean the side glass thoroughly before installing the side panels.
Page 14
Also read the ”Lighting instructions”, before lighting for the first time. NIBE AB/NIBE STOVES · Box 134 · SE-285 23 Markaryd SWEDEN · www.contura.se NIBE Stoves reserves the right to change colours, materials, dimensions and models at any time without special notice. Your dealer can give you the most up to date information.
Need help?
Do you have a question about the C 556 and is the answer not in the manual?
Questions and answers