Table of Contents
Advertisement
INSTALLATION, OPERATION AND
MAINTENANCE INSTRUCTIONS
MACH 9 RV ROOF TOP AIR CONDITIONER /
HEAT PUMP AND REMOTE CONTROLLER
TABLE OF CONTENTS
I.
II.
III.
IV.
V.
VI.
VII.
VIII.
Assembly
P/N: 1980-040
RV Products Division
230/240 VAC, 1ø, 50Hz
SERVICE CONTACT:
Coast RV Pty Ltd.
PO BOX 6287 • SILVERWATER NSW 1811 Australia
Tel: +61-2-9645 7600 • technical@coastrv.com.au
FOR
IX.
2
2
ii.
2
iii.
2
iv.
Initial Configuration of the Hand Held
v.
4
4
vi.
5
vii.
6
viii.
ix.
x.
LED Lights & Buttons on Ceiling
xi.
xii.
xiii.
8
8
8
8
8
8
8
10
10
10
10
11
11
11
01-12-2016
Advertisement
Table of Contents
Related Manuals for Coleman MACH 9
Summary of Contents for Coleman MACH 9
-
Page 1: Table Of Contents
RV Products Division INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS 230/240 VAC, 1ø, 50Hz MACH 9 RV ROOF TOP AIR CONDITIONER / HEAT PUMP AND REMOTE CONTROLLER TABLE OF CONTENTS Operation and Maintenance General Information Model & Serial Numbers Heat Pump Sizing Operating Guidelines III. -
Page 2: General Information
II. HEAT PUMP SIZING These instructions are a general guide for installing the MACH 9, 230/240 VAC 50Hz Coleman-Mach roof top The ability of a heat pump in the cooling mode to cool heat pumps. For specific heat pump details, it will be... - Page 3 Once the heat pump has been leveled, some additional IMPORTANT shimming may be required above the interior ceiling assembly. The heat pump and the interior ceiling TO PREVENT DAMAGE TO THE WIRING AND assembly must have a squared installation relationship BATTERY, DISCONNECT THE BATTERY CABLE FROM THE POSITIVE BATTERY TERMINAL BEFORE before they are secured together.
-
Page 4: Securing The Heat Pump To The Roof
V. SECURING THE HEAT PUMP TO THE ROOF INSTALLER MUST PROVIDE POLE A mounting frame is supplied with the ceiling assembly. DISCONNECT FOR ACTIVE AND NEUTRAL. Follow the steps below to secure the heat pump to the MAXIMUM OVERCURRENT PROTECTIVE DEVICE roof. -
Page 5: System Wiring Diagram
VII. SYSTEM WIRING DIAGRAM OVERLOAD OPTIONAL COMPONENTS AND WIRING BLOWER MOTOR MOTOR BLOWER CAPACITOR CAPACITOR COMPR. CAPACITOR TERMINAL BLOCK COMPR REVERSING VALVE CONDENSATE SOLENOID ORNG PUMP MOTOR 3 "W" CONNECTIONS 1 EVAPORATOR FOR FURNACE CONTROL FREEZE SENSOR HIGH VOLTAGE 4 FOR THIS APPLICATION, 2 OUTDOOR SUPPLY WIRING REMOVAL OF TAB IS NOT... -
Page 6: Installing The 9430A451 Ceiling
VIII. INSTALLING THE 9430A451 CEILING E. Plug in the room temperature sensor to the receptacle ASSEMBLY (Refer to Figures 5 and 6) on the ceiling assembly shroud. Raise the shroud NOTE: The following step by step instructions must up near the mount frame and push the temperature be performed in sequence to insure a quick and easy sensor up through the center opening of the air chute installation. - Page 7 CEILING ASSEMBLY PATCH CORD ROOM TEMPERATURE SENSOR TOP SIDE OF CEILING SHROUD CEILING ASSEMBLY SHROUD CEILING ASSEMBLY GRILLES CEILING ASSEMBLY FILTERS FIGURE 6 This concludes the installation of the system. The following pages contain the operating and maintenance instructions.
-
Page 8: Operation And Maintenance
X. OPERATION AND MAINTENANCE iii. ADJUSTING THE AIR FLOW These instructions are a general guide for operating and maintaining the MACH 9, 230/240 VAC, 50Hz, The conditioned air is distributed through the ceiling Coleman -Mach roof top heat pumps and remote hand ®... -
Page 9: Battery Indicator
Return Air Louver Front Slide Rear Slide Return Air Louver Supply Louvers BATTERY INDICATOR (Only visible when battery is low) SET TEMP ROOM TEMP COOL HEAT AUTO HIGH POWER UP / DOWN Turns Unit On or Off Adjust various set points including AUTO MORN TIMER... -
Page 10: Follow Me
vii. FOLLOW ME In normal operation a temperature sensor in the ceiling assembly senses the temperature and controls the operation of the Air Conditioner or Heat Pump. Follow Me switches this control to a temperature sensor on the hand held controller. To activate Follow Me, press the Follow Me button for 3 seconds and release. -
Page 11: Assembly
LED LIGHTS AND BUTTONS ON THE xii. ROUTINE MAINTENANCE CEILING ASSEMBLY. One of the biggest advantages to your new Coleman-Mach The ceiling assembly has a two color LED to indicate if heat pump is that the maintenance needed to keep the unit the unit is in Cooling or Heating. - Page 12 DATE OF PURCHASE: (Heat pump) Name of Purchaser: Street: City: State: Zip: Place Model No. / Serial No. Sticker Here Coast RV Pty Ltd trading as Coast to Coast RV Services ABN 49 097 104 492 - ACN 101 461 330 PO Box 6287, Silverwater NSW 1811 AUSTRALIA Ph (02) 9645 7600 - Fax (02) 9645 7699...
Need help?
Do you have a question about the MACH 9 and is the answer not in the manual?
Questions and answers