Operation; Getting Started - Clarke-tech HD 5000C User Manual

Operation

6.1 Getting Started

After your receiver is powered on, proceed with installation as follows :
1) Menu Language Setting
Turn on your TV and receiver.
The pop-up menu for language selection will appear.<Figure 6.1.1>
Select one language and press to proceed.
<Figure 6.1.1>
2) Country Setting
Select a country and press the button on.
<Figure 6.1.2>
12
6.1 Getting Started
3) Antenna Setup
Press the MENU button to display the main menu.
Use / and / to move in the menu.
CH VOL VOL
CH
Press on 'Dish Setting'. The following window will appear. <Figure 6.1.3>
If you have a motorized dish, press
Note : Enter a 4-Digit password if need arise. The default password is '0000'.
<Figure 6.1.3>
Select the item that you want to edit, and set its parameters as desired. <Dish Setting>
- LNB Power : Select among ON/OFF/13V/18V.
- LNB Type : Select among Single/Universal/OCS.
- LNB Freq : Set the frequency of the LNB oscillator.
- 22KHz : When not AUTO, set the signal path from LNB or switch by selecting a control
signal among 0/22KHz.
- DiSEqC switch : Select DiSEqC protocol among OFF/1.0/1.1 as appropriate for your
configuration.
- Committed/Uncommitted : Select the DiSEqC port.
Select the item that you want to edit and set its parameters as desired. <Motorized
Setting>
- Frequency : If the default TP frequency is not appropriate, you can select another TP
frequency at which to check for signal.
- DiSEqC Motor : Select DiSEqC protocol among OFF/1.2/USALS as appropriate for your
Motor.
on 'Motorized Setting'. < Figure 6.1.4>
<Figure 6.1.4>
13