Vending Machine Information; Initialising The Data-Base - Necta Korinto Espresso Programming Manual

5 Miscellaneous
5.1 D.A. registry
5.1.1 Install. date
5.1.2 Prog. m/c code
5.1.3 Oper. code entry
5.2 Initialising DB
P 268 rev. 1.0
5 Miscellaneous

5.1 Vending machine information

5.1.1 Installation date
This function is used for storing the current date of system as
installation date of the vending machine. This date will be
indicated on the statistics printout.
5.1.2 Setting the machine code
This function is used for changing the 8-digit numeric code
identifying the machine (set to 0 by default).
5.1.3 Setting the operator code
This function is used for changing the 6-digit numeric code
identifying the group of machines (set to 0 by default).

5.2 Initialising the data-base

This function is used for "initialising" the machine, resetting all
data to default values. This function should be used if there is a
memory data error or when the software is replaced. Except
for the general electronic counter, all statistical data is reset.
When confirming this function some parameter settings are
requested, and namely:
- COUNTRY
Intended as type of basic doses for the different selections. The
available "countries" vary according to the models.
- LAYOUT
A number of Button/Selection combinations to choose from is
provided for each dose type model (the combinations available
for each layout are indicated in the dose selection table
supplied with the machine).
- TANK
Defining whether the water supply is:
OFF - from the mains
ON - from an internal/external tank
When confirming the options the message "Working" is
displayed for a few seconds.
Technician Menu 07-2006