Panasonic EY7880 Operating Instructions Manual page 6

WARNING:
• Do not use other than the Panasonic
battery packs that are designed for use
with this rechargeable tool.
• Do not dispose of the battery pack in a
fire, or expose it to excessive heat.
• Do not drive the likes of nails into the
battery pack, subject it to shocks, dis-
mantle it, or attempt to modify it.
• Do not allow metal objects to touch the
battery pack terminals.
• Do not carry or store the battery pack in
the same container as nails or similar
metal objects.
• Do not charge the battery pack in a
high-temperature location, such as
next to a fire or in direct sunlight. Other-
wise, the battery may overheat, catch
fire, or explode.
• Never use other than the dedicated
charger to charge the battery pack.
Otherwise, the battery may leak, over-
heat, or explode.
• After removing the battery pack from
the tool or the charger, always reattach
the pack cover. Otherwise, the battery
contacts could be shorted, leading to a
risk of fire.
. ASSEMBLY
Attaching or Removing Bit
Chuck
NOTE: Grease for bit
Grease the oval indentation
on the bit with the supplied
grease at least once a month.
1. To mount the bit
1-1. Insert a bit into the mounting hole,
and turn it slightly to locate an en-
gaged position.
1-2. At the engaged position, push the
bit as far as it goes. Make sure that
the bit is fixed by pulling it.
2. To dismount the bit
2-1. Depress the chuck cover and pull
the bit.
Attaching or Removing Bat-
tery pack
Battery holder
The battery pack is designed to be in-
stalled by proceeding two steps for safety.
Make sure the battery pack is installed
properly to the main body before use.
Battery pack Installation and Removal
-For removal-
Push the battery holder (
While the battery pack release button
is held up, (
laterally and pull out the pack. (
Battery
holder
-For installation-
To attach the battery pack, line up the
alignment marks on the body of the
tool and the battery pack, (
insert the battery pack. (
• After you hear the battery pack
clicks when inserting it, keep in-
serting it firmly until the lever locks
it to click once more.
- 6 -
SDS PLUS type
shank
).
) move the battery pack
Release
lever
)
)
) and