Advertisement
Quick Links
39225 (160-SP)
39226 (160M-SP Metric)
Rivet Nut setting Tool (Spin /Pull)
Instructions & Parts List
160-SPM (39226) Metric
This is our most powerful air/hydraulic rivet nut setting tool. This spin-pull
tool automatically threads the fastener onto the mandrel.
Pressing and holding the trigger in position will set the Rivet Nut and
reverse itself out automatically in one operation. Located at the bottom of
the tool is a totally adjustable stroke length rotating knob to suit any grip
range. A swivel air inlet is also included for increased mobility. No
complicated tear down is required to adjust the stroke or to change thread
sizes... both adjustments and changes are done outside the tool. The 39225
½
handles Rivet-Nut thread sizes 6-32" through
-13" and the 39226 handles
Rivet-Nut thread sizes 4mm through 12mm.
Weight: 6 lbs.
CAUTION:
ALWAYS WEAR SAFETY GLASSES WHEN OPERATING TOOL
44 Campanelli Parkway
Stoughton, MA 02072
Customer Service: 800-343-3633
www.alcoafasteningsystems.com
1
Advertisement
Related Manuals for Marson 39225
Summary of Contents for Marson 39225
- Page 1 A swivel air inlet is also included for increased mobility. No complicated tear down is required to adjust the stroke or to change thread sizes… both adjustments and changes are done outside the tool. The 39225 ½ handles Rivet-Nut thread sizes 6-32” through -13”...
- Page 2 Air Feed Use only compressed air. Check airline for damage from humidity & contaminants. In order to protect the tool from premature wear it is recommended a filter separator & regulator assembly be used. A lubricator is not necessary but a water separator is highly recommended.
-
Page 3: Maintenance
MAINTENANCE ADDITION OF HYDRAULIC FLUID The Hydraulic oil should be topped off after a long period of usage or when there is a power loss of the tool. Put the tool in a vertical position rotating the knob (M) towards the plus sign + up to the end of the stroke, and remove plug (I) by using a 4mm Allen wrench (supplied). - Page 4 Changing Mandrel and Nosepiece The tool is supplied with mandrels (A) and nosepieces (B) for setting Rivet Nuts. Depending on the Rivet-Nut thread size it may be necessary to change mandrel (A) and nosepiece (B). This can be done by loosening nosepiece lock nut (C) using a 22mm wrench and remove nosepiece (B) and spacer (Q) if it ranges from 6-32”...
- Page 5 Adjusting Stroke Length (Preliminary Operations) Before using the tool and after each change of thread size, the stroke should be adjusted according to the dimensions, type of insert and thickness of material rivet nut is to be installed in. Before setting rotation of knob (M) in the direction indicated either decreases (-) or increases (+) the clamping force (h).
- Page 6 Working Problem When it is necessary to unscrew mandrel from the Rivet nut remove push rod (P) from it position (1). See diagram below...
-
Page 7: Parts List
Parts List...
Need help?
Do you have a question about the 39225 and is the answer not in the manual?
Questions and answers