Tyre Pressure Monitoring - Skoda Fabia Owner's Manual

An audible signal is also emitted.

Tyre pressure monitoring


Introduction
This chapter contains information on the following subjects:
Save tyre pressure values
Save tyre pressure values and infotainment display
Save tyre pressure values by pressing a button
The tyre pressure monitoring function (hereinafter known as "system") moni-
tors the tyre pressure while driving.
When changing the tyre inflation pressure, the warning light illuminates in
the instrument cluster and an audible signal is heard.
Information on the procedure for the indication of change in tyre pressure val-
ues » page 34.
The system can only function properly if the tyres have the prescribed tyre
pressure and this pressure values are stored in the system.
WARNING
The general information relating to the use of assistance systems must
■
be observed » page 114, in section Introduction.
The correct tyre pressure values is always the driver's responsibility. The
■
tyre pressure should be checked regularly
The system cannot warn in case of very rapid loss of tyre pressure, e.g. in
■
the event of a sudden puncture.
Save tyre pressure values

Read and observe on page 126 first.
The tyre pressure valuesare always stored in the system, if one of the follow-
ing events is present.
▶
Change of tyre pressure values.
▶
Change one or more wheels.
▶
Change in position of a wheel on the vehicle.
▶
The warning light in the instrument cluster.
126
Driving
126
126
127
» page 161.
The storage of the tyre pressure values depends on equipment, either in the
infotainment or by pressing a button.
WARNING
Before storing the tyre pressures they must be inflated to the specified in-
flation pressure » page 161. If incorrect pressure values are storedthe sys-
tem may not warn even with a tyre pressure that is too low.
CAUTION
The tyre pressure values should be stored every 10 000 km or once a year to
ensure proper system function.
Save tyre pressure values and infotainment display

Read and observe on page 126 first.
›
Inflate all of the tyres to the specified inflation pressure.
›
Switch on the ignition.
›
The Infotainment switches on.
›
Press the button in the Infotainment and then in the display the function

keys one after the other Vehicle status.
›
By using the function keys   select the menu item Tyre Pressure Loss Indi-
cator.
›
Press the button  SET » Fig. 148.
In addition, follow the instructions that appear on the display.
A message in the display informs about the storage of the tyre pressure val-
ues.
Note
When a warning light in the instrument cluster appears, the affected tyre
can be displayed on the infotainment
Fig. 148
Button for storing the pressure
values/example of the display:
the system suggests a change to
the front-left tyre pressure
» Fig. 148.