Troubleshooting Hkts System - Harman Kardon HKTS 200/230 SUB Service Manual

Harman/Kardon
HKTS 60BQ/230
Troubleshooting
This unit is designed for trouble-free operation. Most problems that users encounter are due to operating errors. So if you have a problem, first check this list for a possible solution. If
the problem persists, consult your authorized harman kardon service centre.
Problem
If there is no sound from any of the speakers:
If there is no sound coming from one speaker:
If there is no sound coming from the center speaker:
you can find additional troubleshooting information in the FAQs link on the Support page at www.harmankardon.com.
Solution
• Check that the receiver/amplifier is on and a source is playing.
• Make sure that all wires and connections between the receiver/amplifier and the speakers are
connected properly.
• Make sure none of the speaker wires is frayed, cut or punctured.
• Review the proper operation of your receiver/amplifier.
• Check that the balance control on your receiver/amplifier is not set all the way to one channel.
• Check your receiver/amplifier's speaker setup procedure to make sure that he speaker in
question has been enabled and its volume level has not been turned all the way down.
• Make sure that all wires and connections between the receiver/amplifier and the speaker are
connected properly.
• Make sure the speaker wires are not frayed, cut or punctured.
• Check your receiver/amplifier's speaker setup procedure to make sure that the center speaker
has been enabled and its volume level has not been turned all the way down.
• Make sure that all wires and connections between the receiver/amplifier and the center speaker
are connected properly.
• Make sure the speaker wires are not frayed, cut or punctured.
• If your receiver is operating in Dolby
set to Phantom.
HKTS 200 SUB/230 + 210 SUB/230 Service Manual
Troubleshooting
Pro logic mode, make sure that the center speaker is not
® ®
Page 5 of 18 13