Canon Pro900 Mark II Service Manual

Continuous ink supply system

Download this manual

CONTINUOUS INK SUPPLY SYSTEM INSTALLATION INSTRUCTION FOR

Canon Pro9000 / Mark II printer

Caution:

Always keep the ink reservoirs on the same level as the printer.

To ensure that the ink does not fill the air chamber when refilling your unit, it is imperative that the air filter is

replaced with the travel plug and that both the travel plug and refill plug are not removed at the same time.

Do not remove your old cartridge until you have the CIS system primed and ready to install (to prevent the drying of

heads). In addition, make sure you are getting perfect nozzle checks before installing the CIS system. The CIS system

won't be able to work properly if the nozzles are previously clogged.

Most people get a perfect nozzle check the first time after installing the continuous Ink Supply system; others may need

to run two or three cleaning cycles and let the printer sit for a while before they get the perfect results.

Installation Procedures

1. Switch the printer off, open the lid, the take out the print head.

2. Install the silicon seals to the printer head; this will close the air gap between the cartridge and print head.

3. Put the print head back to printer.

4. Take the cartridges, keeping the cartridges higher than the ink tank, and then remove all the orange caps from the

cartridges. (Get some paper towel ready in case of leaking)

Page 1 CONTINUOUS INK SUPPLY SYSTEM INSTALLATION INSTRUCTION FOR Canon Pro9000 / Mark II printer Caution: Always keep the ink reservoirs on the same level as the printer. To ensure that the ink does not fill the air chamber when refilling your unit, it is imperative that the air filter is replaced with the travel plug and that both the travel plug and refill plug are not removed at the same time.
Page 2 Place down each cartridge according to the color. Make sure every cartridge in the correct position by press down the cartridge until you hear the “click” sound for each cartridge. You can attach one clip in the center of the link, then arrange the tube, please make sure the tubes are not twisted, you need to leave the lid open after you install the ciss Here is another way to setup the tubes.
Page 3 Place the lid holder on the top of the printer to lift the lid when it closed. This will give enough space for the ink tube to move. Place make sure the tube is not twisted when you close the lid. ------------------------------------------------------------------------------------------------------------------------------------------------------------- Place the ink reservoir next to the printer, the ink reservoir should be on the same level as the printer...
Page 4 Install the air filter to the air hole, the fat end going down. Fold a piece of paper, insert it to the lid switch hole to touch the sensor , so the printer will think the lid is closed and ready to print.