Network; Configuring The Appliance; Serial Connection Via Console Port - Barracuda Networks F10 Installation Manual

Network

The ethernet connector
255.255.255.0.
In standard configuration and upon delivery, port
Please read the Quick Configuration Guide found on the USB stick for in-depth information about this.

Configuring the Appliance

In order to configure the appliance please copy the Barracuda NG Admin application from the USB
thumb drive to your management PC first.

Serial Connection via Console Port

In order to establish a console connection to the appliance using a serial cable, you need to configure
the serial port on the terminal using the following parameters:
Table 5
Management PC Serial Port Config Parameters
Parameter
Baud
Bits
Stop bit
Parity
Handshake
12 Connecting to the Network and Configuring
is preconfigured with the IP address 192.168.200.200 and the netmask
1
is configured to be assigned an uplink via DHCP.
4
Value
19200
8
1
None
None