Parts supplied NOTE: No other fuel-burning appliance can be installed in the Remove parts bag from dryer drum. Check that all parts were same closet as a dryer. included. Installation Clearances The location must be large enough to allow the dryer door to open fully.
Electrical Requirements Product Dimensions This dryer is supplied without an electric cord and plug. It must be connected by a competent electrician to a single-phase Dimensions shown with feet extended 2,5 cm (1") from bottom of dryer. electricity supply at the voltage shown on the dataplate, using a terminal block cover suitable fixed wiring installation in accordance with local and 27,9 cm...
Recommended Earthing Method Improper venting can cause moisture and lint to collect indoors, which may result in: It is your responsibility to contact a qualified electrical installer Moisture damage to woodwork, furniture, paint, to ensure that the electrical installation is adequate and in wallpaper, carpets, etc.
3. Determine the number of elbows needed. Vent System Length NOTE: Do not use vent runs longer than specified in the Vent Length Chart. 1. Select the route that will provide the straightest and most The following chart helps you determine your maximum vent direct path outdoors.
3. Start to screw legs into holes by hand. Use an adjustable Connect Vent wrench or 2,5 cm (1") hex-head socket wrench to finish turning legs until you reach the ridge with the diamond 1. Connect vent to dryer outlet using 10 cm (4") clamp. If marking.